I'm using WinIB from Mellanox's site. I don't know if it's a free/checked build. I could not find hklm\system\current control set\services\srp.
Also, I found the following in the release notes: To complete the SRP driver installation, an SRP target must be detected and a Subnet Manager must be running in the subnet. Upon the detection of an SRP target, the "New Hardware Found" Wizard pops up. - Select Install Automatically and click Next. This installs the I/O unit device. Once completed, the "New Hardware Found" Wizard pops up again. - Select Install Automatically and click Next. This installs the SRP driver. I can ping my srpt machine over IPoIB. However, I didn't get any "New Hardware Found" Wizard. Did I miss anything? Also, where can I get a checked build of WinIB/WinOF? Thanks, Erez Tzachi Dar wrote: > Please look at: > http://lists.openfabrics.org/pipermail/ofw/2006-October/001297.html > For how to trace SRP > > Thanks > Tzachi > > >> -----Original Message----- >> From: [EMAIL PROTECTED] >> [mailto:[EMAIL PROTECTED] On Behalf Of Erez Zilber >> Sent: Tuesday, May 29, 2007 2:41 PM >> To: [email protected] >> Subject: [ofw] Cannot start SRP initiator >> >> Hi, >> >> >> I've installed WinIB from Mellanox's site >> (https://docs.mellanox.com/dm/WinIB/MSI/WinIB_x64_1_3_0_2000.msi). >> However, the SRP initiator fails to start. It says that "This >> device cannot start. (Code 10)". >> >> >> Why is that? Can I see logs anywhere? >> >> >> Thanks, >> >> -- >> >> ____________________________________________________________ >> >> Erez Zilber | 972-9-971-7689 >> >> Software Engineer, Storage Team >> >> Voltaire - _The Grid Backbone_ >> >> __ >> >> www.voltaire.com <http://www.voltaire.com/> >> >> >> >> _______________________________________________ >> ofw mailing list >> [email protected] >> http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw >> >> _______________________________________________ ofw mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw
