Erez, What target are you using?
Best regards, Erez Cohen Field Application Development Manager Mellanox Technologies Ltd. Tel : + 972 - 4 - 9097200 ext 378 Cell : + 972 - 54 - 5468801 Fax : + 972 - 4 - 9593245 www.mellanox.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Erez Zilber Sent: Wednesday, May 30, 2007 12:06 PM To: Tzachi Dar Cc: [email protected] Subject: Re: [ofw] Cannot start SRP initiator Tzachi Dar wrote: > > > >> -----Original Message----- >> From: Erez Zilber [mailto:[EMAIL PROTECTED] >> Sent: Tuesday, May 29, 2007 7:13 PM >> To: Tzachi Dar >> Cc: [email protected] >> Subject: Re: [ofw] Cannot start SRP initiator >> >> I'm using WinIB from Mellanox's site. I don't know if it's a >> free/checked build. I could not find hklm\system\current control >> set\services\srp. >> > The default build that you have is free. In order to have a checked > build you can do one of the following; > 1) build it your self :-) > 2) go to the same page on the Mellanox site and you fill find a zip > file with symbols. This file contains all the checked binaries as well > so you can copy srp.sys from the checked directory to the > system32\drivers directory. > > > It seems that the path has changed to hklm\system\current control set\services\ibsrp\Parameters. I can see it now. The current values are: DebugFlags = ffffff DebugLevel = 2 What should I put there in order to see the required logs? BTW - maybe it's a good idea to put this info in the SRP wiki page. >> Also, I found the following in the release notes: >> >> >> To complete the SRP driver installation, an SRP target must be >> detected and a Subnet Manager must be running in the subnet. >> >> Upon the detection of an SRP target, the "New Hardware Found" >> Wizard pops up. >> I can see "Mellanox referenced SRP target" under "SCSI and RAID controllers" in the device manager. Does it mean that the initiator machine "sees" the SRP target? Anyway, it has the following error: Windows cannot start this hardware device because its configuration information (in the registry) is incomplete or damaged. (Code 19) Again, please tell me what should I do in order to supply more info about it. >> - Select Install Automatically and click Next. This installs the I/O >> unit >> device. >> >> Once completed, the "New Hardware Found" Wizard pops up again. >> - Select Install Automatically and click Next. This installs the SRP >> driver. >> >> I can ping my srpt machine over IPoIB. However, I didn't get any "New >> Hardware Found" Wizard. >> Did I miss anything? >> > > Are you using windows xp32 bit? SRP doesn't work there. > No, I'm using win 2003 > If not, can you go to the device manager and do scan for HW changes? > This should help. > If this doesn't help than your problem is probably at the bus driver > at the code that should create the virtual device and not at the SRP > itself that is not loaded. _______________________________________________ ofw mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw _______________________________________________ ofw mailing list [email protected] http://lists.openfabrics.org/cgi-bin/mailman/listinfo/ofw
