Hello List. I recently installed and configured OmniOS on a HP Microserver N40L NAS box.
In time to time my box hangs/freezes for some seconds, when I try to SSH into the box or execute some SMART-INFO functions. And then it gives me access. In my /var/adm/messages i have these messages : May 8 20:10:41 blackbox scsi: [ID 107833 kern.warning] WARNING: /pci@0 ,0/pci-ide@14,1/ide@0 (ata0): May 8 20:10:41 blackbox timeout: abort request, target=1 lun=0 May 8 20:10:41 blackbox scsi: [ID 107833 kern.warning] WARNING: /pci@0 ,0/pci-ide@14,1/ide@0 (ata0): May 8 20:10:41 blackbox timeout: abort device, target=1 lun=0 May 8 20:10:41 blackbox scsi: [ID 107833 kern.warning] WARNING: /pci@0 ,0/pci-ide@14,1/ide@0 (ata0): May 8 20:10:41 blackbox timeout: reset target, target=1 lun=0 May 8 20:10:41 blackbox scsi: [ID 107833 kern.warning] WARNING: /pci@0 ,0/pci-ide@14,1/ide@0 (ata0): May 8 20:10:41 blackbox timeout: reset bus, target=1 lun=0 May 8 20:10:42 blackbox gda: [ID 107833 kern.warning] WARNING: /pci@0 ,0/pci-ide@14,1/ide@0/cmdk@1,0 (Disk0): May 8 20:10:42 blackbox Error for command 'read sector' Error Level: Informational May 8 20:10:42 blackbox gda: [ID 107833 kern.notice] Sense Key: aborted command May 8 20:10:42 blackbox gda: [ID 107833 kern.notice] Vendor 'Gen-ATA ' error code: 0x3 My current configuration is the System(OmniOS) is installed onto a SATA disk located at port 5 on the Microserver. (yes i have the BIOS hacked which allows for SATA 3G/AHCI functions on the port other ports) Then I have 4x SATA disks configured in RAIDZ I double checked my BIOS configuration, and it seems that I have misconfigured the OS disk into a IDE mode, but not AHCI. So when I change the mode to AHCI, I get the GRUB loader and the OmniOS logo after that, but suddenly the machines restarts again and never boots into the system all the way. So my question is, is there any way for my to reconfigure my running-system to use AHCI instead of IDE,ATA mode ? Is it enough to boot up a usb live system and issue a "zpool import -f rpool", and then finally "zpool export rpool" with a running BIOS-config as AHCI and then restart the computer and let it boot normally ? I read somewhere that the import/export functions would update the device path, but I have no experience on this issue. Any help would be much appreciated. Thanks allot people. Best regards, Svavar O Reykjavik - Iceland
_______________________________________________ OmniOS-discuss mailing list OmniOS-discuss@lists.omniti.com http://lists.omniti.com/mailman/listinfo/omnios-discuss