Great. "stmqspi setparms" fixes our need. Thanks lot for your support.
---
** [tickets:#211] Enable break points on QSPI debugging + OpenOCD**
**Status:** new
**Milestone:** 0.9.0
**Created:** Thu Nov 29, 2018 07:45 AM UTC by shaalik
**Last Updated:** Tue Dec 11, 2018 05:27 PM UTC
**Owner:** nobody
Hi,
We were able to debug from QSPI NOR flash on custom stm32H7 + NOR board, and
possible to do step in and step over. However it is not possible to set or
clear break points on run time. How can we enable the break points on QSPI NOR
flash debugging
---
Sent from sourceforge.net because [email protected] is
subscribed to https://sourceforge.net/p/openocd/tickets/
To unsubscribe from further messages, a project admin can change settings at
https://sourceforge.net/p/openocd/admin/tickets/options. Or, if this is a
mailing list, you can unsubscribe from the mailing list.
_______________________________________________
OpenOCD-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/openocd-devel
