My mistake - I read too fast. Correction inline. I've used the amt_jtagaccel on v0.1.0, so I'm pretty sure it works. I don't have a working test setup right now, though.
On January 28 2010, Matthew Fletcher wrote: > Can anyone verify that this interface is still functional in 0.4 ? Out > of 0.4-rc1, 0.3.1 and an old rev.131 fetch only the old rev.131 fetch > works to a certain extent. In all cases the openocd was built from > source on cygwin with only amt_jtagaccell and parport_give_io enabled > in configure. Since you have a test-case of sorts, could you do a git-bisect on it? Just type the following: git bisect start git bisect good v0.1.0 git bisect bad v0.3.1 Then, repetitively: ./bootstrap ./configure --whatever-opts-you-use make -j3 src/openocd -f /path/to/your/config.conf git bisect <good|bad> Once it says you're done, run "git describe" and report the output here. _______________________________________________ Openocd-development mailing list Openocd-development@lists.berlios.de https://lists.berlios.de/mailman/listinfo/openocd-development
