No! Just a controller and a compute node!
G.
On Sun, 12 Jan 2014 15:12:56 -0800, Remo Mattei wrote:
Do you have a network node?
This is important not sure since I did not read all the emails so
sorry if this has been already asked.
Remo
Inviato da iPhone ()
Il giorno Jan 12, 2014, alle ore 14:54, Georgios Dimitrakakis
<gior...@acmac.uoc.gr> ha scritto:
Thank you all for your suggestions!
I was (and still am) confused since the manual says that the
nova-network create command should be run on the controller node. That
is obviously failing because no br100 is defined. So do I have to put
br100 on the controller as well or should I just create the network on
the compute node?
What are the differences in these setups?
Best,
G.
On Thu, 09 Jan 2014 10:05:54 -0600, Dimitri Maziuk wrote:
On 1/9/2014 4:11 AM, Georgios Dimitrakakis wrote:
Hello again!
No the br100 was not created automatically unfortunately! There is
also
this bug report:
https://bugs.launchpad.net/openstack-manuals/+bug/1241331
I'm not 100% sure but I think in my case it did get created
automatically when I tried to fire up the cirros instance the 2nd
time
around... However, I may have created the bridge manually at some
point while fighting with it, I forget.
https://access.redhat.com/site/documentation/en-US/Red_Hat_Enterprise_Linux/5/html/Virtualization/sect-Virtualization-Network_Configuration-Bridged_networking_with_libvirt.html
(from "disable network manager" down to "restart networking or
reboot")
Also check that vhost_net module is loaded (lsmod).
Since it wasn't created automatically I am asking if it has to be
on
both nodes (controller + compute) in order for the network to work
correctly? Furthermore, I would like to know how should it be
bridged in
order to achieve floating (public) IPs?
Compute only: this is the interface VMs use to talk to the world.
Floating IPs are a separate story really -- but if I uderstand the
question correctly, your br100 should be bridged to the subnet
where
your floating IPs are.
I.e. if your eth0 is on 1.2.3.0/24 and your eth1 is on 10.0.0.0/24,
and you want floating IPs in 1.2.3.0/24 range, then you want to
bridge
br100 to eth0.
Dima
_______________________________________________
Mailing list:
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
Post to : openstack@lists.openstack.org
Unsubscribe :
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
--
_______________________________________________
Mailing list:
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
Post to : openstack@lists.openstack.org
Unsubscribe :
http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
!DSPAM:52d31f7528362208261525
_______________________________________________
Mailing list: http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
Post to : openstack@lists.openstack.org
Unsubscribe : http://lists.openstack.org/cgi-bin/mailman/listinfo/openstack
