On 02/26/2015 05:47 AM, Freek de Kruijf wrote:
Op donderdag 26 februari 2015 10:44:17 schreef Andreas Färber:
Am 26.02.2015 um 10:12 schrieb Freek de Kruijf:
Op woensdag 25 februari 2015 23:33:31 schreef Andreas Färber:
Am 25.02.2015 um 22:11 schrieb Freek de Kruijf:
I have a strange problem with Wi-Fi connections to two somewhat
different
Access Points.
Both use the same configuration in "YaST network", apart from SSID and
IP
address. Still the connection does succeed with one AP, but to the other
AP it always fails.
In my experience the most frequent cause of inexplicable AP connection
problems is a misconfigured RTC. If you're using Ethernet too, make sure
NTP is configured.
What do you mean by RTC?
Real time clock, i.e. `date`.
And NTP means Network Tine Protocol?
Yes. Can be configured through the yast time(zone) settings.
Andreas
I have a test set up with the RPi connected via the UTP port and two different
Wi-Fi USB dongles in the two USB ports of the RPi. The clock is synchronized
using NTP via the wired connection. So there is nothing wrong with the RTC and
NTP. The two Wi-Fi interfaces are configured the same way apart from the SSID
and IP address. I exchanged the SSIDs of these interfaces and both connect to
one AP and not to the other AP.
I see a number of red herrings in this thread. The first is that time has
anything to do with it. I also doubt that this has anything to do with RPi or ARM.
The two AP's are *not* configured the same. In your first E-mail, you said that
one uses TKIP and the other uses CCMP. That usually means WPA for the TKIP case,
and WPA2 for CCMP or AES.
Please supply the output of 'ps ax | grep wpa_supplicant'.
Also, please supply the output of 'sudo /usr/sbin/iwlist scan' or 'sudo iw wlan0
scan'. If the device has a name other than wlan0, adjust the second command
accordingly.
It would be helpful if you identified the wireless device and driver.
I have no experience with wicked, but I suspect it is the problem. To my
knowledge, all wifi drivers handle both WPA and WPA2 encryption correctly.
Larry
--
To unsubscribe, e-mail: [email protected]
To contact the owner, e-mail: [email protected]