On 2/12/20 11:56 AM, Matwey V. Kornilov wrote: > 12.02.2020 18:37, ITwrx пишет: >> On 2/12/20 8:59 AM, ITwrx wrote: >>> On 2/12/20 1:49 AM, Matwey V. Kornilov wrote: >>>> Hi, >>>> >>>> It is very strange to hear that. I deployed this image to couple of >>>> Rock64-s week ago. >>>> So, could you please be more specific? What are you trying to do exactly? >>>> >>>> You are supposed to download >>>> openSUSE-Tumbleweed-ARM-JeOS-rock64.aarch64-2020.01.30-Build5.29.raw.xz >>>> uncompress it with `xz -d >>>> openSUSE-Tumbleweed-ARM-JeOS-rock64.aarch64-2020.01.30-Build5.29.raw.xz` >>>> and write .raw file to microsd card as the following `dd_rescue >>>> openSUSE-Tumbleweed-ARM-JeOS-rock64.aarch64-2020.01.30-Build5.29.raw >>>> /dev/your_sd_card_here`. >>> That's what i did, but i'll try it again. I didn't get any errors when >>> writing the image. This time, i'll wipe the sd card and create one fat >>> partition, just to be on the safe side. >>>> Do you have usb rs232 ttl converter to attach the Rock64 console? What >>>> does it say? >>> i did, but i don't remember. It didn't get very far. If it fails this >>> time, i'll copy and paste the output. >>> >>> Thanks >>> >>>> ср, 12 февр. 2020 г. в 10:17, Guillaume Gardet <guillaume.gar...@arm.com>: >>>>> Hi, >>>>> >>>>>> -----Original Message----- >>>>>> From: ITwrx <i...@itwrx.org> >>>>>> Sent: 12 February 2020 03:49 >>>>>> To: opensuse-arm@opensuse.org >>>>>> Subject: [opensuse-arm] Rock64 >>>>>> >>>>>> Thorston/All, >>>>>> >>>>>> i just wanted to report that there are not Rock64 microOS images, only >>>>>> images for >>>>>> the older pine64. >>>>>> >>>>>> Also, the instructions on the Rock64 openSUSE wiki don't work (exactly >>>>>> as they >>>>>> are), using the below linked image file. I don't know what the >>>>>> corresponding >>>>>> "packages" file is for or how to use it, so it was not used in any way. >>>>>> The Rock64 >>>>> The "packages" file is just the list of installed packages in this >>>>> *.raw.xz image. >>>>> >>>>>> openSUSE wiki page didn't mention anything about it. Probably why the >>>>>> board >>>>>> won't boot... :) >>>>>> >>>>>> http://download.opensuse.org/repositories/devel:/ARM:/Factory:/Contrib:/Roc >>>>>> kchip/images/openSUSE-Tumbleweed-ARM-JeOS-rock64.aarch64-2020.01.30- >>>>>> Build5.29.raw.xz >>>>>> >>>>>> Any tips appreciated. >>>>> Added Matwey in Cc who may help. >>>>> >>>>> Cheers, >>>>> Guillaume >>>>> >>>>>> Thanks, >>>>>> >>>>>> ITwrx >>>>>> >>>>>> >>>>>> -- >>>>>> To unsubscribe, e-mail: opensuse-arm+unsubscr...@opensuse.org >>>>>> To contact the owner, e-mail: opensuse-arm+ow...@opensuse.org >> Ok, i misspoke earlier. The first time i didn't extract, then run >> dd_rescue per your instructions. i ran "xzcat [image].raw.xz | dd bs=4M >> of=/dev/sdX iflag=fullblock oflag=direct; sync" (substituting relevant >> info) per the wiki. This time i did use your commands. I got the same >> result and output in the serial console as before. >> >>> U-Boot TPL 2020.01 (Jan 30 2020 - 10:43:44) >>> data training error >>> col error >>> data training error >>> LPDDR3, 800MHz >>> BW=16 Col=12 Bk=8 CS0 Row=16 CS=1 Die BW=8 Size=4096MB >> I don't know much about Arm, so i don't know what that output means. :) > It is very first stage of bootloader. Do you see anything else next? no. That's where it stops, unfortunately. I guess i could try the ALARM install process and see if it stops at the same point, in which case maybe it's an hardware issue. > >> Thanks >> >> >
-- ---- --- Information Technology Works on the net: https://ITwrx.org on the fediverse: @it...@blurts.net -- To unsubscribe, e-mail: opensuse-arm+unsubscr...@opensuse.org To contact the owner, e-mail: opensuse-arm+ow...@opensuse.org