On 2/19/06, James PEARSON <[EMAIL PROTECTED]> wrote: > > > > I have a strange problem when installing beta4 into VMware 4.5.2: > > CD1 and CD2 are installed without problems, but CD3 is not recognized > > - YaST keeps asking for it. > > I use the ISOs and connect them to /dev/hdc in VMware. > > ....Otherwise the installation of > > packages from CD 2-5 will fail afterwards.") - but I'm not sure > > because it fails with CD3. > > > > I had the same problem except that I am using the latest Vmware v5.5 > (VMware-workstation-5.5.1-19175). > > The install process blocked when I gave it the 3rd CD. After hiting > ENTER a couple of times, I finally chose "Ignore" and voila, I had the > same problem for the 4th CD. I chose "Ignore" again and the install > process asked for the 5th CD. The 5th CD ran without any problems and > the installation continued up until "Hardware Configuration" page setup > where there is still a problem on the "Hardware Configuration" setup > page. I believe that is last problem is related to Sax2 configuration > process under Vmware. > > Regards > James > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > I was able to chose eject and then ok to continue with the install however sax2 can't configure the xserver even after installing the vmware tools.
-- David Barker Master CNI, Master CNE, CLE, MCSE, CCNA
