Website Visitor wrote:
I want to auto-route a pcb in PROTEL ,on which there will be routing only at
bottom layer and jumpers on the top layer, but i want to have only straight
jumpers,horizental or vertical both are acceptable, so how i can do it, i am
using protel-99-sec edition, please guide me.
my email is: [EMAIL PROTECTED]
thanks
Posted from Association web site by: Muhammad Kamran
I don't know of any automatic way to do this.
I would lay it out as a double-sided board, placing as much routing as possible
on the bottom site, then making sure any tracks remaining on the top side are
straight, and suitably located so that they can be replaced by jumpers.
--
Peter Bennett
TRIUMF
4004 Wesbrook Mall, Vancouver, BC, Canada
GPS and NMEA info and programs:
http://vancouver-webpages.com/peter/index.html
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
