Hi,
Listen to him,
It is TRUE,
Thanks & Regards
Jeyaraman Ponnurangam
Senior Research Engineer
[EMAIL PROTECTED]
Embedded Wireless Labs Sdn Bhd
www.embeddedwireless.com
The information transmitted is intended only for the person or entity to
which it is addressed and may contain confidential and/or privileged
material. Any review, retransmission, dissemination or other use of, or
taking of any action on reliance upon, this information by persons or
entities other than the intended recipient is prohibited. If you received
this in error, please contact the sender and delete the material from any
computer.
"The only reason time exists is so everything doesn't happen all at once"
----- Original Message -----
From: "Brad Velander" <[EMAIL PROTECTED]>
To: "Protel EDA Discussion List" <[email protected]>
Sent: Wednesday, June 08, 2005 8:35 AM
Subject: RE: [PEDA] Straight jumpers on top layer in auto routing
Muhammad,
You are trying to do the same thing that many before have tried with only
very limited successes. The Protel autorouter is not designed for this
practice (routing single-layer, neither are 'most' autorouters) and it
doesn't do a good job of it. Protel doesn't even support any form of
automated jumper placement in manually routing processes, so what is the
router supposed to do that would make it handle jumpers any better?
You just can't beat the ole human brain-power.
Some people have tried routing it two layers with a big fill or keepout over
the top layer to keep the autorouter from placing tracks on the top side or
a number of other similar work-around. However, the completion rate is low
and then you have to manually clean-up the design and manually put in your
own jumpers anyway. I would route it manually and you would probably find it
to be much faster.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
1925 Kirschner Rd.,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Website Visitor [mailto:[EMAIL PROTECTED]
Sent: June 7, 2005 3:31 PM
To: [email protected]
Subject: [PEDA] Straight jumpers on top layer in auto routing
I want to auto-route a pcb in PROTEL ,on which there will be routing only at
bottom layer and jumpers on the top layer, but i want to have only straight
jumpers,horizental or vertical both are acceptable, so how i can do it, i am
using protel-99-sec edition, please guide me.
my email is: [EMAIL PROTECTED]
thanks
Posted from Association web site by: Muhammad Kamran
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
