Hi, You have 3.3V power supply. I don't think you may expect any output change if your input is below 1.65V. Try to change it to 2V or above and see if your output voltage will change to 0V.
Mira --- tastingfan tastingfan <[EMAIL PROTECTED]> wrote: > > Hi, > > > > I want to simulate a CMOS-Inverter with Protel 2004. > I have two MOSFETs (MOSFET-P and MOSFET-N), one > power supply of 3.3V and one impulse generator which > gives out rectangular waves of 1 kHz. But the result > is wrong! The input has a range from 0V ¨C 1V, > that¡¯s OK. But the output only from 3.072 to > 3.300V. Why is it not zero? > > > > Best Regards > > Tasting_fan > > > > --------------------------------- > DO YOU YAHOO!? > ÑÅ»¢Ãâ·ÑGÓÊÏä£ÖйúµÚÒ»¾øÎÞÀ¬»øÓʼþɧÈų¬´óÓÊÏä > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > > ____________________________________________________ Start your day with Yahoo! - make it your home page http://www.yahoo.com/r/hs ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
