The only suggestion I can think of is to view in draft mode. Peter ----- Original Message ----- From: "Terry Creer" <[EMAIL PROTECTED]> To: "'Protel EDA Discussion List'" <[EMAIL PROTECTED]> Sent: Monday, August 22, 2005 11:39 AM Subject: [PEDA] Overlapping hole DRC?
> Hi All, > > > > In P99SE is there a way to check for holes that overlap? > > > > This is assuming that they are on the same net. > > > > Cheers, > > > > TC > > ---------------------------------------------------------------------------- ---- > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[EMAIL PROTECTED] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[EMAIL PROTECTED] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[EMAIL PROTECTED] > > ---------------------------------------------------------------------------- ---- No virus found in this incoming message. Checked by AVG Anti-Virus. Version: 7.0.338 / Virus Database: 267.10.13/78 - Release Date: 19/08/2005 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[EMAIL PROTECTED]
