That's exactly what I suspected. I was aware of the hole check for two holes in exactly the same position, but we want to check if one hole is overlapping another hole by a certain percentage (ie - we don't want to snap drill bits).
Thanks anyway - I guess it'll have to be done the hard way... TC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dennis Saputelli Sent: Monday, 22 August 2005 12:38 PM To: Protel EDA Discussion List Subject: Re: [PEDA] Overlapping hole DRC? depends on what you mean by 'overlap' if exactly at the same point the DRR shows that otherwise, no AFAIK ds _______________________________________________________________________ Integrated Controls, Inc. Tel: 415-647-0480 EXT 107 2851 21st Street Fax: 415-647-3003 San Francisco, CA 94110 www.integratedcontrolsinc.com Terry Creer wrote: > Hi All, > > > > In P99SE is there a way to check for holes that overlap? > > > > This is assuming that they are on the same net. > > > > Cheers, > > > > TC > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[EMAIL PROTECTED] ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[EMAIL PROTECTED] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[EMAIL PROTECTED] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[EMAIL PROTECTED]
