What a coincidence. I'm just working with a prototype using a ATMega128 on a P99SE board. I've used the QFP14X14-64(N) footprint from the standard IPC square QFP library. It looks to be rather generous on pad width (at the expense of gap), but otherwise OK. In this footprint there are "N" and "T" options which signify where pin 1 is located (corner or middle).
Hope that helps. Steve. On 14 Nov 2005 at 12:25, Brad Kosiance wrote: > I downloaded the following library: > QFP (+-0.8mm pitch, Square) - Corner Index.lib > > that has the following footprints: > QFP14X14-G64/N > QFP14X14-G64/Y1.9N > QFP14X14-G64/Y1.55N > > The data sheet specifies a 14 x 14 mm Body size, 0.8 mm Lead Pitch, > TQFP. I think the QFP14X14-G64/N is the correct footprint. Does anyone > know what the G and N stand for? > > Brad. ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
