If all else fails, try cutting or copying a short track (on the Top layer) into the clipboard, and then paste (a copy of) that track (from the clipboard) onto a pad located on the same layer. Hopefully you will be able to subsequently route from the other end of that track (or at least while Single Layer Mode is selected) without the problems that you are encountering while attempting to route from the pads instead.
I can't guarantee that this will work, ... but it might. Regards, Geoff Harland. > Hi all, > > This is my stupid fault but....... > > I have a over crowded PCB, I have a section (filters) where I have components > top and bottom of the PCB, they are identically aligned ie if you look through > the board, the other side is shadow of the side viewed from. > > The problem is that I am getting a net from the other side when I want to > route one side, in this case I am trying to route the top, but I am grabbing a > bottom net :( > > I have tried selecting the net, selecting all the components pads on the net, > using single layer mode, turning the bottom layer off, all to no avail, I > think this is due to the pad centers being 100% in allingment? > > Any ideas how to do this, or do I need to move all the components off the same > centers ??? > -- > Regards, > > Kat. ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
