Kathy Quinlan wrote: > Hi all, > > I know I am asking a lot of questions, but this is the first "real > design" where I can not do hacks like we do for personal stuff and cosy > clients (the ones we know from going down the pub with etc) > > OK I have a push button on a PCB,it has 4 pins, there are 2 sets of 2 > pins connected internally. I want a track to connect the pins so that I > can use either side of the part to route, (also some suppliers of this > part only provide non linked switches, where the active pins may be > diagonal or vertical). > > Now when I place the track in the library, it comes up on the PCB as a > violation, I have gone to the netlist manager and told it to update free > primitives from component pads, but this does not seem to do the trick :( > > I am not sure how to proceed. Any suggestions ?
OK I RTFM'd AGAIN, I did not realise that you had to do the update PCB from schematic and the Netlist manager stuff :( Not clearly written lol -- Regards, Kat. --------------------------------------------------------------- K.A.Q. Electronics Website: www.kaqelectronics.dyndns.org IM: Yahoo: PinkyDwaggy MSN: [EMAIL PROTECTED] For Everything Electronics Phone: 0419 923 731 --------------------------------------------------------------- -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.385 / Virus Database: 268.3.3/295 - Release Date: 28/03/2006 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
