Hi all, I know I am asking a lot of questions, but this is the first "real design" where I can not do hacks like we do for personal stuff and cosy clients (the ones we know from going down the pub with etc)
OK I have a push button on a PCB,it has 4 pins, there are 2 sets of 2 pins connected internally. I want a track to connect the pins so that I can use either side of the part to route, (also some suppliers of this part only provide non linked switches, where the active pins may be diagonal or vertical). Now when I place the track in the library, it comes up on the PCB as a violation, I have gone to the netlist manager and told it to update free primitives from component pads, but this does not seem to do the trick :( I am not sure how to proceed. Any suggestions ? -- Regards, Kat. --------------------------------------------------------------- K.A.Q. Electronics Website: www.kaqelectronics.dyndns.org IM: Yahoo: PinkyDwaggy MSN: [EMAIL PROTECTED] For Everything Electronics Phone: 0419 923 731 --------------------------------------------------------------- -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.385 / Virus Database: 268.3.3/295 - Release Date: 28/03/2006 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
