Yvet,
I don't know your answer but "human race" and "Autotrax"? Only
hobbyists use "Autotrax" and they aren't part of the human race. 8^>
Beyond my lame humour, do you already have P98 or P99SE? Maybe DXP or
AD6.0? If not you may be looking at only AD6.0 as the older/used Protel
licenses are not readily available on the market. If you really do mean
Autotrax then I am not sure anyone here would have your answer for you, can't
recall seeing Autotrax discussed here since I have been around (approx. 6
years).
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Henry Ford [mailto:[EMAIL PROTECTED]
Sent: Friday, May 12, 2006 8:15 AM
To: [email protected]
Subject: [PEDA] Converting Very Old Protel V3 PCB Files
I have used Protel for years. I use V3.03 for DOS to
be precise, dated (gasp) 1987.
It still works just fine, even on WinXP, but I guess
it really is time to join the rest of the human race
and use Autotrax.
Q: Is there a little program around somewhere that
will allow me to convert my old *.PCB files from the
ancient V3 format into a format suited to the modern
Protel world?
Apologies if there is an answer to this somewhere in a
FAQ or message. I looked first, honest.
Thanks
Yvet
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
