Make sure that the polygon is set to "pour over same net"
[EMAIL PROTECTED] wrote: > Thank you for the advice. I think I will use via's instead of pads and lock > the vias so that they do not disappear as I route. This is not ideal but it > works. > > > In case you wanted more information: > Pad size: 170mil diameter (round) > Pad hole: 93mil diameter > Net: GND > Designator: 0 > > Polygon Net: GND > Polygon Grid Size: 19mil (tried 0 but that did not fix my problem) > Polygon Track Size: 20mil (tried various tack and grid sizes) > Hatch Pattern: 90 degrees (tried various) > > The square gap that appears in the polyon is 189mils by 189 mils. > > Rules: > Minimum Clearance: 0 (also tried -30) > > > I did make a component and a corresponding footprint and connected it to > ground but I still got the same issue. I also tried varying the Polygon > connect style and set the connection width to the width of the pad but I got > strange results. > > The Via solution is the easiest to deal with and as long as I lock down the > vias they will not disappear as I route. Thank you for the suggestion Abd > ul-Rahman. > > Trentino -- Peter Bennett TRIUMF 4004 Wesbrook Mall, Vancouver, BC, Canada V6T 2A3 Phone: 604-222-7456 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
