> There is, in fact, a checkbox under the advanced tab of the pad > properties to achieve unplatedness.... > > Leo
The unplatedness option only exists if I change the pad from a multilayer to top layer type pad with a drill hole. This actually worries me since the DRC & power planes may not see the hole on any other layer other than the top. This still doesn't sound too correct. ____________ Brian G. ----- Original Message ----- From: "Leo Potjewijd" <[EMAIL PROTECTED]> To: "Protel EDA Discussion List" <[email protected]> Sent: Wednesday, September 27, 2006 4:29 PM Subject: Re: [PEDA] P99se, Footprint Library editor, Unplated holes. > At 27/09/06 22:11, Brian Guralnick wrote: >>To create unplated holes, I just made the pad size 0, it this the right >>way >>to create unplated pad holes? > > Actually, no. > It may or may not result in an unplated hole, but you will run into > trouble with the minimum annular ring... > There is, in fact, a checkbox under the advanced tab of the pad > properties to achieve unplatedness.... > > Leo > > > > ____________________________________________________________ > You are subscribed to the PEDA discussion forum > > To Post messages: > mailto:[email protected] > > Unsubscribe and Other Options: > http://techservinc.com/mailman/listinfo/peda_techservinc.com > > Browse or Search Old Archives (2001-2004): > http://www.mail-archive.com/[email protected] > > Browse or Search Current Archives (2004-Current): > http://www.mail-archive.com/[email protected] > ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
