I remembered you asking about this before, so I searched through the archives a little. It seems that every time you set up a new system on your network, you encounter this challenge. See the thread beginning with this message in particular:
http://lists.pdxlinux.org/pipermail/plug/2018-February/088693.html Short version: it seems that you have your Synology configured to allow access based on IP address. Your usual strategy to allow new systems to connect is to give the new system the IP address of the system it replaced. In the case of adding an additional system, you would have to log in to the Synology's admin interface and add the new IP address for access to its data. -wes On Wed, Dec 18, 2019 at 11:44 AM John Jason Jordan <[email protected]> wrote: > I have been happily using my Synology NAS for quite a while, but after > moving everything to a new computer the mount line in fstab no longer > works: > > 192.168.1.115:/volume1/Synology /media/jjj/Synology nfs auto,user 0 0 > > When I first set this up it took a fair-sized thread here before I > finally got it right. Hope it won't take that long again. > > Oh, and 192.168.1.115 is correct; at least it responds to that when I > ping it. And the folder /media/jjj/Synology definitely exists. The rest > of it is beyond my ken. > > Any suggestions welcome! > _______________________________________________ > PLUG mailing list > [email protected] > http://lists.pdxlinux.org/mailman/listinfo/plug > _______________________________________________ PLUG mailing list [email protected] http://lists.pdxlinux.org/mailman/listinfo/plug
