Even when you apply v to the entire y, you must first split y into cells
so that it can be applied to v. Every verb operates on cells whose
rank is no higher than the rank of the verb.
In other words, the splitting is not part of u@:v - it is part of
executing v itself.
Henry Rich
On 3/28/2020 2:58 PM, 'Sergey Kamenev' via Programming wrote:
My comments relate to the third column of the diagram.
1. I don’t understand why it is written on the diagram that Y should
be splitted into cells
if the verb V should be applied to the whole argument Y.
2. The diagram says the verb V must apply individually to each cell Y,
and at the top of the page it says that the verb must apply to the
entirety argument Y.
28.03.2020 21:41, Henry Rich пишет:
I don't see what's wrong with the picture. Can you be specific?
y must always be split into cells, regardless of whether you use & or
&: . The difference comes in whether you collect the results before
applying them to u .
Henry Rich
On 3/28/2020 2:36 PM, 'Sergey Kamenev' via Programming wrote:
Health to all!
Page:
https://code.jsoftware.com/wiki/Vocabulary/ampco
Written at the top of the page:
Applies verb v to each argument in its entirety, and then applies
verb u to the result(s) of v
The diagram says about &: (bottom to top):
* split y into cell
* apply v to each cell
Nice day!
Sergey Kamenev
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
--
This email has been checked for viruses by AVG.
https://www.avg.com
----------------------------------------------------------------------
For information about J forums see http://www.jsoftware.com/forums.htm
