In message <[EMAIL PROTECTED]> Tony Firshman <[EMAIL PROTECTED]> wrote:
> > On Wed, 28 Jan 2004 at 10:23:14, Michael Grunditz wrote: > (ref: <[EMAIL PROTECTED]>) > > > > >Hi all ! > > > >Despite all your help last time I cant figure out how > >to get my Q40 talk whith qpc2. > > > >On the Q40: > > > >baud 9600 > >lrespr sernet > >snet 1 > >sernet > > > >and the equivalent on qpc2. > What is the wiring of your cable? > > If both are 9 pin this should work: > > 2 RX <-> 3 TX > 3 TX <-> 2 RX > 4 DTR <-> 6 DSR > 5 GND <-> 5 GND > 6 DSR <-> 4 DTR > 7 RTS <-> 8 CTS > 8 CTS <-> 7 RTS > 9 CD NC > > Most null modem cables will be like this. > > Try testing the connection first direct using a terminal program each > end. Then type characters each side. If you see them uncorrupted, then > you have a handshaking problem at speed. > If you see nothing at all either end then you have problems. > It could be one or other serial card is not working or not set up > properly. The Q40 end is the most likely problem, as PC bios will > default to an OK state. The cable works ok between qpti -> qpti. /Michael