I have a Question regarding
"
.) Configure yum to access the rpmforge repo by following the instructions
for your distro/version at B2 here:
http://dag.wieers.com/rpm/FAQ.php#B
"
what if my distro is centOS4.4
would I then use Red Hat Enterprise Linux 4 / *i386*:
I do not see a centOS4 under " supported"
thanks!
sorry if this is a really obvious thing - thanks again
j
Eric Shubert wrote:
[EMAIL PROTECTED] wrote:
That's not enough of the log file to tell what caused the bad exit status.
Please give us a little more, like tail -n50 perhaps, or however much it
That was tail -n100 actually. Let's see... here's the whole thing since I'm not
sure where I should start it.
<snip>
REQUIRED module out of date: HTML::Parser
<snip>
Did you miss the message I posted last night? Here's what I wrote:
That's better. Here's what you need to do:
.) Configure yum to access the rpmforge repo by following the instructions
for your distro/version at B2 here:
http://dag.wieers.com/rpm/FAQ.php#B
.) use yum to install the required perl module which is missing:
# yum -y install perl-HTML-Parser
.) install any other optional modules you care to install, e.g.:
# yum -y install perl-Mail-SPF perl-IP-Country perl-Mail-DKIM
.) run qtp-newmodel, and be sure to use a fresh sandbox
This should work fine for you as long as you haven't updated CPAN. Refer to
earlier list posts regarding MakeMaker for details about that.
---------------------------------------------------------------------
QmailToaster hosted by: VR Hosted <http://www.vr.org>
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]