My brother did what he could, lots of dust and rocks (I live on a dirt road) and it is working…….sounds much better
praying it stays fixed for awhile From: wheelch...@aol.com [mailto:wheelch...@aol.com] Sent: Friday, February 13, 2015 4:43 PM To: zoocr...@windstream.net; gah17...@aol.com; quad-list@eskimo.com Subject: Re: [QUAD-L] Ramp Problems When using a power-washer, cover any electric motors and components in plastic to protect them. Make sure that all rocks, sand, road tars and debris are removed. A dry lube is better than wet lubing that may attract dust and debris. Best Wishes -----Original Message----- From: nichole rohling <zoocr...@windstream.net> To: Gah17582 <gah17...@aol.com>; quad-list <quad-list@eskimo.com> Sent: Fri, Feb 13, 2015 11:47 am Subject: RE: [QUAD-L] Ramp Problems no, it’s an in floor ramp. spoke w/ a gentleman yesterday who said the tracks that are accessible through the service panel which is on driver’s side underneath the van probably need to be cleaned and then lubricated with a high pressure silicone lubricant called lithium grease. We’re going to try that today…….praying it fixes it J Nicki From: gah17...@aol.com [mailto:gah17...@aol.com <mailto:gah17...@aol.com?> ] Sent: Thursday, February 12, 2015 1:23 PM To: zoocr...@windstream.net Subject: Re: [QUAD-L] Ramp Problems Hi, I don't think IMS uses hydraulics, I think they are all electric. It is probably a limit switch, but I'm not familiar with the 2002. The 2002 is a ramp that you can push open and it unfolds in an emergency, right? I don't think the bearings are your issue. In a message dated 2/11/2015 4:08:07 P.M. Central Standard Time, zoocr...@windstream.net writes: If I win the Oklahoma powerball tonight I won’t need this answered but since that probably isn’t going to happen……….. I have a 2002 Dodge Grand Caravan IMS Rampvan 1. my ramp isn’t coming all the way out and isn’t pulling all the way back in (probably 1” to 1 ½” off)……..any ideas? 2. I need to replace 5 roller bearings that are under the ramp and wonder if I can buy somewhere…..they are a about 7/8” long, roller/bearing is just over ½” in diameter and have CRS – 8 O2R 10RR on them I have pictures of the roller bearings if any of you think you can help me then I can email them to you Thanks Nicki C5/6