Hi all,
does anybody know this? My Squeezebox Radio (bought on eBay as fully
defective) refuses to do anything WiFi-related. It registers with
Ethernet, no problem, it plays well, something appears to be wrong about
WiFi though. Attempted factory and Xilinx resets, both to no avail.
My observations so far:
- switching to WiFi will immediately abort the scan for available
networks (if it happens at all), and show that no networks could be
found, although every WiFi other device is giving me 3 to 5 networks,
two of which are my own. One access point is sitting less than one
meter from the SBR
- WiFi status info shows everything unset, and the WiFi symbol in the
bottom right corner stays red all the time
- entering valid WiFi information for the desired network ends in the
SBR not being able to connect to it (takes ~ 30 seconds to find that
out)
If the WiFi chip in the Radio were defective, I would assume that the
scan would still take a while to return without success, or the entire
device crashing during hardware access to the WiFi chip. It seems more
as if there is a driver issue and the SBR does not even attempt to make
use of the WiFi hardware at all. There are no error codes being shown or
anything else happening that points out anything unusual. I'm clueless.
Regards and thank you all in advance! :)
Joe
1x Squezeebox Classic SB2
5x Squeezebox Classic SB3 (one waiting for repair)
7x Squeezebox Boom (two waiting for repair)
1x Transporter
1.5x Controller (one waiting for repair)
1.5x Touch (one waiting for repair)
------------------------------------------------------------------------
JoeMuc2009's Profile: http://forums.slimdevices.com/member.php?userid=23131
View this thread: http://forums.slimdevices.com/showthread.php?t=108221
_______________________________________________
Radio mailing list
[email protected]
http://lists.slimdevices.com/mailman/listinfo/radio
