Patrick, On the bike with the rear wired tail light, just ran the wire across the rack held down with zip ties, then a few wraps around one of the rack stays, along the top tube (again held with zip ties), to the brake cable housing, then down parallel to the bike computer wire to the light. At that point, the wires were soldered together and covered in shrink wrap.
Very basic, but should keep the tail light wires away from sludge and crud in winter. It's a non-Rivendell (Surly LHT) with Tubus rear rack and the B&M Toplight Line Plus bolted to the rear rack. Have not come up with a satisfactory wiring system for the E3 and corresponding tail light on the Sam Hillborne. The previous wiring actually caused the headlight to fail. Admit to a bit of fear of trying it again. Additionally, don't like the Supernova tail light as I prefer something with a reflector. But no other tail light is compatible with the E3. Eric Platt St. Paul, MN On Sep 7, 11:31 am, PATRICK MOORE <bertin...@gmail.com> wrote: > Eric: will you share with us your rear light wiring strategy? Thanks. > -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To post to this group, send email to rbw-owners-bunch@googlegroups.com. To unsubscribe from this group, send email to rbw-owners-bunch+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/rbw-owners-bunch?hl=en.
