Hi Bill,
It sounds like you’re talking about a purlin type setup – 4’ sounds a little far apart but I guess that’s what you have to deal with. If you have a corrugated metal roof, we’ve used S-5 CurruBrackets screwed through the metal and into the purlins and then either run the solar rail up and down the roof or install a sub-rack system (with strut or angle aluminum) perpendicular to your solar rail. Best, August *From:* RE-wrenches [mailto:re-wrenches-boun...@lists.re-wrenches.org] *On Behalf Of *frenergy *Sent:* Friday, April 29, 2016 6:55 AM *To:* RE-wrenches *Subject:* [RE-wrenches] Goofy roofing Recently, a customer had a metal roof (not standing seam) installed by a "handyman". Pretty clean installation however for some reason he ran 1X6 stringers across the roof on the 1/2" plywood deck spaced about every 4 feet (as you go from ridge to eaves). Of course the roofing screws are at the stringers. I'm sure he had a *great* reason for doing so. So now I have been asked to install an array on this roof. You can feel how "soft" the roof is as you walk on it of course because you are walking on air-below-metal for most of the roof. Stringer locations don't jive with possible feet/post locations for rail. I'm usually pretty good at problem solving but I'm accepting ideas. Bill Feather River Solar Electric Bill Battagin, Owner 4291 Nelson St. Taylorsville, CA 95983 530.284.7849 CA Lic 874049 www.frenergy.net
_______________________________________________ List sponsored by Redwood Alliance List Address: RE-wrenches@lists.re-wrenches.org Change listserver email address & settings: http://lists.re-wrenches.org/options.cgi/re-wrenches-re-wrenches.org List-Archive: http://www.mail-archive.com/re-wrenches@lists.re-wrenches.org/maillist.html List rules & etiquette: www.re-wrenches.org/etiquette.htm Check out or update participant bios: www.members.re-wrenches.org