Master Boot Record (MBR) When you turn on your PC, the processor has to begin processing. However, your system memory is empty, and the processor doesn't have anything to execute, or really even know where it is. To ensure that the PC can always boot regardless of which BIOS is in the machine, chip makers and BIOS manufacturers arrange so that the processor, once turned on, always starts executing at the same place, FFFF0h. This is discussed in much more detail here.
In a similar manner, every hard disk must have a consistent "starting point" where key information is stored about the disk, such as how many partitions it has, what sort of partitions they are, etc. There also needs to be somewhere that the BIOS can load the initial boot program that starts the process of loading the operating system. The place where this information is stored is called the master boot record (MBR). It is also sometimes called the master boot sector or even just the boot sector. (Though the master boot sector should not be confused with volume boot sectors, which are different.) The master boot record is always located at cylinder 0, head 0, and sector 1, the first sector on the disk (see here for more on these disk geometry terms). This is the consistent "starting point" that the disk always uses. When the BIOS boots the machine, it will look here for instructions and information on how to boot the disk and load the operating system. The master boot record contains the following structures: Master Partition Table: This small table contains the descriptions of the partitions that are contained on the hard disk. There is only room in the master partition table for the information describing four partitions. Therefore, a hard disk can have only four true partitions, also called primary partitions. Any additional partitions are logical partitions that are linked to one of the primary partitions. Partitions are discussed here. One of the partitions is marked as active, indicating that it is the one that the computer should use for booting up. Master Boot Code: The master boot record contains the small initial boot program that the BIOS loads and executes to start the boot process. This program eventually transfers control to the boot program stored on whichever partition is used for booting the PC. Due to the great importance of the information stored in the master boot record, if it ever becomes damaged or corrupted in some way, serious data loss can be--in fact, often will be--the result. Since the master boot code is the first program executed when you turn on your PC, this is a favorite place for virus writers to target. Next: Primary, Extended and Logical Partitions -----Original Message----- From: Edward Dekkers [mailto:[EMAIL PROTECTED]] Sent: Tuesday, January 08, 2002 7:09 PM To: [EMAIL PROTECTED] Subject: Re: System is hanging with 'LI' only showing > Isn't it the MBR that contains the partition info? I doubt it. when you re-write the MBR, you don't lose your partitions? _______________________________________________ Redhat-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-list _______________________________________________ Redhat-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-list
