----- Original Message -----
Sent: Saturday, July 27, 2002 10:03
PM
Subject: Help w/ Tulip NIC and Buslogic
SCSI card
All,
I've been building some new machines and run into
a problem. In my systems, I have Znyx ZX346 NIC's, these are four port 10/100
PCI cards using thte DEC tulip 21140 chip. I also have a Buslogic (Mylex)
BT-958D in each system. Using RH 7.3, the systems run fine with either the
SCSI card or the NIC install, but NOT both. It seems there is some conflict
between them. I've done some reading and it seems that the tulip NIC's are
well supported by Linux as is the Buslogic card (and as I said they both work
fine on their own).
When I have them both in the system, RH will boot
fine. It configures eth0 fine and all looks good. However, I can not send any
packets in or out of the system. The SCSI card appears to work correctly as I
can r/w to the drives on that card. When the tulip driver is being loaded at
boot time I get an error message (dmesg) about the PCI instance having an
unknow header. I also get tulip: missing EEPROM at xxxx, interface may not
work correctly. Would changing the order the drivers are loaded help possibly?
Anyone have other ideas that might get me both network and SCSI
connectivit? Any and all help is greatly appreciated.
TIA,
Mark
---
Outgoing mail is certified Virus
Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.380
/ Virus Database: 213 - Release Date:
7/24/2002