Hi Ian
Yes it is possible.
You will have to add an inexpensive additional ctcss
encoder.Link the cos of the reciever to both the
transmitter and the tone board.If you you have
experience in ctcss board installtions it should be
straight forward.After that with the help of a
schematic follow the PTT line until you can add a
simple CAPACITOR electrolitic -normalli\y on the input
to a switching opamp.
The second way is to allow the transmitter to ptt with
a tail-use the cos line to "mute" the ctcss tone in
and around the sub audible pot on the txco board.
Good luck
Regards
Bradley Glen ZS5WT
--- ian wells <[EMAIL PROTECTED]> wrote:
>
> hi guys
> i am wondering if there is a way to setup or to
> program a t2010 to transmit
> a tail without the ctcss tail on the end of a
> transmission (ie to be used as
> the transmitter in a a repeater so while the
> receiver receives a signal it
> activates the t2010 transmitter with a ctcss ,and
> when the receive signal
> ceases the transmitter continues with a 1-2 second
> tail without the
> ctcss ).At the moment i have 2 t2010 connected
> direct through so while a
> signal is received the transmitter transmitts with
> the ctcss
> Thank you
> Ian Wells
> Kerinvale Comaudio
> mail service 1017,
> Biloela,4715.
> www.kerinvalecomaudio.com.au
> 1-email- [EMAIL PROTECTED]
> 2-email- [EMAIL PROTECTED]
>
>
>
>
>
>
>
> Yahoo! Groups Links
>
>
> [EMAIL PROTECTED]
>
>
>
>
__________________________________
Do you Yahoo!?
Yahoo! Mail - 50x more storage than other providers!
http://promotions.yahoo.com/new_mail
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
