Valuflex is the nickname for the slightly-lower-cost line of pre-made Superflex jumpers from Andrew. Valuflex jumpers use a machine-installed connector (most are crimped on), not the usual screw-together connectors that you would buy normally. I've used them a few times, but don't regularly buy them. I prefer to make my own jumpers; I've had problems with factory-made jumpers from both Andrew and Cablewave in the past.
--- Jeff On Fri, 18 Feb 2005 11:36:01 -0600, Doug Zastrow wrote > Hi Mike, > > You are right, ValueFlex is NOT in Andrew Catalog 38 nor anywhere to > be readily found. > > I was shopping the A/F CommSupply Catalog and found the ValueFlex > jumpers on page 53. (Caution if downloading the catalog; it is 7 MB.) > > I think your advice to stick with SuperFlex is the best course to follow. > > Thanks... > > Doug > > ----- Original Message ----- > From: Mike Perryman > To: Repeater-Builder@yahoogroups.com > Sent: Friday, February 18, 2005 10:38 AM > Subject: RE: [Repeater-Builder] Andrew Valueflex vs. Superflexible > Jumpers > > Doug, > > Youve got me stumped... I can find no references to "Valueflex" > on the Andrew site, or in catalog 38. I did see a reference to > "sureflex" factory made jumpers... > > I hate to hazard a guess... other than to say I personally would > stick with the standard FSJ4-50B (also known as superflex), or LDF4- > 50A(low-loss cable). For short jumper type runs, the standard FSJ4- > 50B cable should be more than sufficient. > > Sorry I can't be more helpful... > > mike > -----Original Message----- > From: Doug Zastrow [mailto:[EMAIL PROTECTED] > Sent: Friday, February 18, 2005 10:18 AM > To: repeater-builder@yahoogroups.com > Subject: [Repeater-Builder] Andrew Valueflex vs. Superflexible Jumpers > > Hello All, > > I'm selecting replacement jumpers for a two-meter repeater > system. Specifically the repeater to duplexer and duplexer antenna > port to antenna Heliax jumpers. > > Andrew offers Valueflex and Superflexible jumpers. Should I > steer clear of the Valueflex? > > Thanks.... > > Doug, WB0UPJ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/