Ok & Thanks All - I have Pin 8 grounded to the Icon ( was already according to
Simpson 260) The
control head has been removed - We do have a GE test set hooked up with good
microphone. The vol.
and squelch controls are inside the chassis like the NHRC. We are grounding pin
25 for ptt and it kills
the spkr but no RF output. - Same occurrence with the remote microphone. We
have two transmitter
strips that were both supposed to be from working radios. Same with either
strip. I know there is a
( Friday 13th ) very small issue somewhere we have overlooked. We are working
on this primarily to
learn a bit more about the Mastr II's and let me say - it is sure a learning
experience as we have called on
brain cells that haven't been disturbed for over a quarter century. Dave &
Kenny's - GE Project
NØATH / WØOLY
----- Original Message -----
From: "Brent" <[EMAIL PROTECTED]>
To: <Repeater-Builder@yahoogroups.com>
Sent: Friday, May 13, 2005 6:29 PM
Subject: Re: [Repeater-Builder] (unknown)mastr II exciter
ok
P902
PIN # 8 is freq 1 select
pin 1 is located at the bottom right if you are look at it with the
connection to the right and solder side down.
Mastr II exciter
Pin 2 CG hi
PIn 3 CG lo
Pin 4 A-
Pin 5 Mic Lo
Pin 6 Mic hi
PIn 7 Reg 10v
Pin 8 F1 Select
Pin 9 F2 Select
Pin 10 F3 select
Pin 11 F4 Select
Pin 12 OSC 10V
Pin 13 COMP
Pin 14 F5 select
Pin 15 F6 select
Pin 16 F7 select
Pin 17 F8 select
this is for the 19D4238652G2 and G4 exciter board
406-512mhz
you should be ok on the vhf also..
----- Original Message -----
From: "Coy Hilton" <[EMAIL PROTECTED]>
To: <Repeater-Builder@yahoogroups.com>
Sent: Friday, May 13, 2005 5:35 PM
Subject: [Repeater-Builder] (unknown)
It's Pin 8 of the exciter connector It took me about 10 seconds to
look at the label inside a near by MASTRII. The label is not
registered with the pins, so Count from left to right starting with
the first pin on the left. If you really need to Know what pin on
the ICOM it is just use your trusty OHM meter. I would tell you but
I don't Know which ICOM or Which Exciter you have.
73
AC0Y
--- In Repeater-Builder@yahoogroups.com, NØATH <[EMAIL PROTECTED]> wrote:
> Hello Kevin or Eric ? Any luck yet on telling me what pin to
ground on the mastr II mobile Icon
> to get the transmitter to operate on channel 1.
> I feel like I've been forgotten.
> It is an 8 channel 100 watt vhf mobile - I have sent the numbers
you requested. I think they are
> correct.
>
> Dave / NØATH
Yahoo! Groups Links
---
[This E-mail scanned for viruses at TNWEB LLC]
---
[This E-mail scanned for viruses at TNWEB LLC]
Yahoo! Groups Links
Yahoo! Groups Links
<*> To visit your group on the web, go to:
http://groups.yahoo.com/group/Repeater-Builder/
<*> To unsubscribe from this group, send an email to:
[EMAIL PROTECTED]
<*> Your use of Yahoo! Groups is subject to:
http://docs.yahoo.com/info/terms/
