hey Joe Yes I have tried that and it will only go to 42mhz They are 35mhz to 40mhz cans and they will only go to 42mhz. The tuning rod is not the real problem I have it out and all I will need to do is cut more threads on the threaded rod so it will unscrew further up the can but the cooper sleave is what I need to get out to cut off and Im not sure how it comes out. There is a big nut on top of the can but have put some preasure on it but have had no luck on geting it to break loose. I dont wont to mess up the can so I am giving it a shot on here to see if anyone has done this are has any info on how short to cut the sleave. I have tried a plug in the end of the can to make it 8" shorter but that does not make a big change. The A B and C models are 80" long and the D is 72" But with the test I have done shows that the length of the cans is not the problem, it has a little effect, but very little. I can not find any info on the internal specs on these. Telewave and TX RX dont have any internal specs or can they tell me much info on them. If I make this work I will post the info on here for all to have I just need to figure out how to get my hands on the internal specs and how to remove the sleave and the length of the D model and the loop info will be the next thing I am going to need. Freddy N4XW
--- In Repeater-Builder@yahoogroups.com, Joe <k1ike_m...@...> wrote: > > Hello Freddy, > > Have you tried to tune it to your frequency? You may not need to cut > the inner tuning rod, as it just may have enough travel to go to your > frequency. It's worth a shot. My 42MHz cans went to 53Mhz with no > problems. The loops will probably need to be modified. > > 73, Joe, K1ike > > > > Doug N3DAB > > > > --- In Repeater-Builder@yahoogroups.com, "ag4uw" <ag4uw@> wrote: > > > >> Hello group!! I am looking for someone that has info on mods for the > >> wacom 604B duplexers to put them in the ham band 604D. And does anyone > >> know how to remove the the tuning rod from the wacom duplexers??? Does the > >> big nut on the top unscrew or can it be removed??? I am looking for info > >> but have not been able to find anything on doing this mod. If I can remove > >> the copper rod from the can I was going to try to cut it shorter,(If you > >> know how long the tuning rod is on the D model please let me know. It can > >> not be cut off from the end because it has finger stock on that end and > >> will have to be cut off at the top. If anyone has any info please let me > >> know. if you have the info on how long to cut the tunning rod off are know > >> how long the tuning rod is on the 604D or have any info on how to remove > >> the rod please let me know. any info you may have would be great. Thanks > >> Freddy N4XW > >> > >> > > > > > > > > > > ------------------------------------ > > > > > > > > Yahoo! Groups Links > > > > > > > > > > >