Leopold Palomo-Avellaneda wrote: > A Dilluns 19 Novembre 2007, Jan Kiszka va escriure: >> Leopold Palomo-Avellaneda wrote: >>> Hi, >>> >>> after recompiling the kernel (2.6.23) and xenomai (trunk) and rtnet >>> (trunk) I'm having the same problems. So, I would like to delimite them. >>> Trying to use the rtcap, I got that wireshark doesn't see it. I have done >>> the following steps. Please could you look it if I'm missing something >>> obvious? >>> >>> mknod /dev/rtnet c 10 240; >>> insmod modules/rtnet.ko; >>> insmod modules/rtipv4.ko; >>> insmod modules/rtpacket.ko; >>> insmod modules/rt_e1000.ko; >>> insmod modules/rtcap.ko; >>> sudo ./sbin/rtifconfig rteth0 up 10.0.0.1 promisc netmask 255.255.255.0; >>> >>> doing this if I run wireshark, rteth0 doesn¡t appears as interface. I can >>> see only eth1 , lo and any. >>> >>> Please, >>> what I'm doing wrong? >> ifconfig rteth0 up >> etc. >> (the RTcap sniffing interfaces show up as a pseudo network devices under >> Linux). > > :-( > > please Jan, could you add this sentence to the readme.rtcap documentation?
Clarification patches to the doc will be happily accepted! :) > Because although the documentations says: > > After these shadow devices are started up using ifconfig > [.......] > switched to promiscuous mode when it is configured: > > rtifconfig <rtdevX> up <IP> promisc > > > I understand all the time that the device is started by rtifconfig in promisc > and not that I _must_ rtifconfig + promisc and after ifconfig rteth0 > > Regards, > > Leo > > PS maybe I could see what is happen with the controller ping ... > > Jan -- Siemens AG, Corporate Technology, CT SE 2 Corporate Competence Center Embedded Linux ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ RTnet-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/rtnet-users
