Re: [Chevelle-list] fuel problem
On Tue, Nov 30, 2010 at 10:13:41PM -0500, Jim Thompson wrote: Sounds like vapor lock. Do you have rubber fuel line? After sitting over night? I doubt it. -- Bob Holtzman Key ID: 8D549279 If you think you're getting free lunch, check the price of the beer
Re: [Chevelle-list] fuel problem
There is a bolt that can be removed to hold the pushrod up but it really isn't that hard to line the pump arm up with the pushrod and hold it in place. If you do use the bolt method to hold the rod use a soft bolt and just finger tighten it as you don't want to nick the rod and have it bind. When you test a fuel pump the pressure can be ok but you also need to check the volume, I am not sure what the exact volume should be but a good rule of thumb is a pint in 30 seconds. Chum Nault _ From: chevelle-list-boun...@chevelles.net [mailto:chevelle-list-boun...@chevelles.net] On Behalf Of harkema...@aol.com Sent: Monday, November 29, 2010 9:17 PM To: chevelle-list@chevelles.net Subject: Re: [Chevelle-list] fuel problem This was kind of on the line I was thinking, when the fuel pressure is measured- I quickly get 6 psi but it drops right off when I stop cranking. I also had the fuel line problem as discussed but replacing that did not do much good, neither did the carb overhaul. are there any tricks out there for replacing the fuel pump? don;t some blocks have a tapped hole in the front where you can put a bolt and bottom out against the push rod (holding it in place) thanks for all the advice!!! Harlan In a message dated 11/29/2010 8:42:57 PM Central Standard Time, a396...@fidnet.com writes: I just went through that with my 327 and Edelbrock carb. The fuel pump diaphragm had a small puncture that released the pressure between the pump and carb. Even the clear fuel filter I use was being drained dry. Dale
Re: [Chevelle-list] fuel problem
Every hard starting SB Chevy I ever owned, had either a weak or bad fuel pump which made it hard to start. Yes pull the short bolt and stick longer bolt which will hold the fuel pump push rod up. Larry - Original Message - From: harkema...@aol.com To: chevelle-list@chevelles.net Sent: Monday, November 29, 2010 7:17:13 PM Subject: Re: [Chevelle-list] fuel problem This was kind of on the line I was thinking, when the fuel pressure is measured- I quickly get 6 psi but it drops right off when I stop cranking. I also had the fuel line problem as discussed but replacing that did not do much good, neither did the carb overhaul. are there any tricks out there for replacing the fuel pump? don;t some blocks have a tapped hole in the front where you can put a bolt and bottom out against the push rod (holding it in place) thanks for all the advice!!! Harlan In a message dated 11/29/2010 8:42:57 PM Central Standard Time, a396...@fidnet.com writes: I just went through that with my 327 and Edelbrock carb. The fuel pump diaphragm had a small puncture that released the pressure between the pump and carb. Even the clear fuel filter I use was being drained dry. Dale I just went through that with my 327 and Edelbrock carb. The fuel pump diaphragm had a small puncture that released the pressure between the pump and carb. Even the clear fuel filter I use was being drained dry. Dale
Re: [Chevelle-list] fuel problem
I just recently changed the fuel pump on my 67 327 and tried the bolt trick. Even using a longer bolt that I could physically feel in the push rod hole, the bolt never contacted the push rod; the rod ran underneath the bolt. Wound up having to remove the plate, grease up the rod with some bearing grease to help keep it against the camshaft. I remember it working in the past but didn’t on this engine. ??? Dale From: chevelle-list-boun...@chevelles.net [mailto:chevelle-list-boun...@chevelles.net] On Behalf Of z16chevelle...@comcast.net Sent: Tuesday, November 30, 2010 3:19 PM To: The Chevelle Mailing List Subject: Re: [Chevelle-list] fuel problem Every hard starting SB Chevy I ever owned, had either a weak or bad fuel pump which made it hard to start. Yes pull the short bolt and stick longer bolt which will hold the fuel pump push rod up. Larry - Original Message - From: harkema...@aol.com To: chevelle-list@chevelles.net Sent: Monday, November 29, 2010 7:17:13 PM Subject: Re: [Chevelle-list] fuel problem This was kind of on the line I was thinking, when the fuel pressure is measured- I quickly get 6 psi but it drops right off when I stop cranking. I also had the fuel line problem as discussed but replacing that did not do much good, neither did the carb overhaul. are there any tricks out there for replacing the fuel pump? don;t some blocks have a tapped hole in the front where you can put a bolt and bottom out against the push rod (holding it in place) thanks for all the advice!!! Harlan In a message dated 11/29/2010 8:42:57 PM Central Standard Time, a396...@fidnet.com writes: I just went through that with my 327 and Edelbrock carb. The fuel pump diaphragm had a small puncture that released the pressure between the pump and carb. Even the clear fuel filter I use was being drained dry. Dale
Re: [Chevelle-list] fuel problem
Dale: Maybe the bolt was not long enough. I cant remeber the length but I have always just grabbed a longer bolt and finger tightened it into the side of the bolt' Larry - Original Message - From: Dale a396...@fidnet.com To: The Chevelle Mailing List chevelle-list@chevelles.net Sent: Tuesday, November 30, 2010 2:15:45 PM Subject: Re: [Chevelle-list] fuel problem I just recently changed the fuel pump on my 67 327 and tried the bolt trick. Even using a longer bolt that I could physically feel in the push rod hole, the bolt never contacted the push rod; the rod ran underneath the bolt. Wound up having to remove the plate, grease up the rod with some bearing grease to help keep it against the camshaft. I remember it working in the past but didn’t on this engine. ??? Dale From: chevelle-list-boun...@chevelles.net [mailto:chevelle-list-boun...@chevelles.net] On Behalf Of z16chevelle...@comcast.net Sent: Tuesday, November 30, 2010 3:19 PM To: The Chevelle Mailing List Subject: Re: [Chevelle-list] fuel problem Every hard starting SB Chevy I ever owned, had either a weak or bad fuel pump which made it hard to start. Yes pull the short bolt and stick longer bolt which will hold the fuel pump push rod up. Larry - Original Message - From: harkema...@aol.com To: chevelle-list@chevelles.net Sent: Monday, November 29, 2010 7:17:13 PM Subject: Re: [Chevelle-list] fuel problem This was kind of on the line I was thinking, when the fuel pressure is measured- I quickly get 6 psi but it drops right off when I stop cranking. I also had the fuel line problem as discussed but replacing that did not do much good, neither did the carb overhaul. are there any tricks out there for replacing the fuel pump? don;t some blocks have a tapped hole in the front where you can put a bolt and bottom out against the push rod (holding it in place) thanks for all the advice!!! Harlan In a message dated 11/29/2010 8:42:57 PM Central Standard Time, a396...@fidnet.com writes: I just went through that with my 327 and Edelbrock carb. The fuel pump diaphragm had a small puncture that released the pressure between the pump and carb. Even the clear fuel filter I use was being drained dry. Dale
Re: [Chevelle-list] fuel problem
Sounds like vapor lock. Do you have rubber fuel line? From: chevelle-list-boun...@chevelles.net [mailto:chevelle-list-boun...@chevelles.net] On Behalf Of harkema...@aol.com Sent: Monday, November 29, 2010 8:22 PM To: Chevelle-list@chevelles.net Subject: [Chevelle-list] fuel problem what could be the possible cause on a 350 chev engine after sitting over night the car will not start, it cranks and cranks and i can pump the heck out of it to no avail, i need to pour a small amount of fuel down the carb, than it will start and run just fine. if it sits a few hours it will start fine on its own. has to be like 8 or more hours. thanks Harlan
Re: [Chevelle-list] fuel problem
I don’t know. It was fairly long and I remember running it down until the nose butted against the inside wall of the hole and I could feel the threads. Push rod still slipped right by it. ? Dale From: chevelle-list-boun...@chevelles.net [mailto:chevelle-list-boun...@chevelles.net] On Behalf Of z16chevelle...@comcast.net Sent: Tuesday, November 30, 2010 4:26 PM To: The Chevelle Mailing List Subject: Re: [Chevelle-list] fuel problem Dale: Maybe the bolt was not long enough. I cant remeber the length but I have always just grabbed a longer bolt and finger tightened it into the side of the bolt' Larry
Re: [Chevelle-list] fuel problem
I would check the choke and accelerator pump on the carb. Darren From: chevelle-list-boun...@chevelles.net [mailto:chevelle-list-boun...@chevelles.net] On Behalf Of harkema...@aol.com Sent: Monday, November 29, 2010 7:22 PM To: Chevelle-list@chevelles.net Subject: [Chevelle-list] fuel problem what could be the possible cause on a 350 chev engine after sitting over night the car will not start, it cranks and cranks and i can pump the heck out of it to no avail, i need to pour a small amount of fuel down the carb, than it will start and run just fine. if it sits a few hours it will start fine on its own. has to be like 8 or more hours. thanks Harlan
Re: [Chevelle-list] fuel problem
Leaking fuel bowl also. On Mon, Nov 29, 2010 at 7:24 PM, Darren dar...@hopeandcompany.com wrote: I would check the choke and accelerator pump on the carb. Darren *From:* chevelle-list-boun...@chevelles.net [mailto: chevelle-list-boun...@chevelles.net] *On Behalf Of *harkema...@aol.com *Sent:* Monday, November 29, 2010 7:22 PM *To:* Chevelle-list@chevelles.net *Subject:* [Chevelle-list] fuel problem what could be the possible cause on a 350 chev engine after sitting over night the car will not start, it cranks and cranks and i can pump the heck out of it to no avail, i need to pour a small amount of fuel down the carb, than it will start and run just fine. if it sits a few hours it will start fine on its own. has to be like 8 or more hours. thanks Harlan -- Rick Schaefer 72 TPI El Camino
Re: [Chevelle-list] fuel problem
I had that problem on my Impala a couple of years ago and discovered that the fuel line had developed a leak back by the tank and would completely dry out overnight. It took two mechanics a week to find it. They kept looking around the engine until we put it on the lift to do some exhaust work and saw the rotten section. Hope your problem is that simple. Alex LaRue LaRue Insurance, Inc.(800)303-3518 Fax (866)591-7318 P O Box 119 54 Lincoln Square Hodgenville, KY 42748 ACES 4711 www.LaRueInsurance.net www.LaRueClassics.com From: chevelle-list-boun...@chevelles.net [mailto:chevelle-list-boun...@chevelles.net] On Behalf Of harkema...@aol.com Sent: Monday, November 29, 2010 8:22 PM To: Chevelle-list@chevelles.net Subject: [Chevelle-list] fuel problem what could be the possible cause on a 350 chev engine after sitting over night the car will not start, it cranks and cranks and i can pump the heck out of it to no avail, i need to pour a small amount of fuel down the carb, than it will start and run just fine. if it sits a few hours it will start fine on its own. has to be like 8 or more hours. thanks Harlan
Re: [Chevelle-list] fuel problem
I just went through that with my 327 and Edelbrock carb. The fuel pump diaphragm had a small puncture that released the pressure between the pump and carb. Even the clear fuel filter I use was being drained dry. Dale From: chevelle-list-boun...@chevelles.net [mailto:chevelle-list-boun...@chevelles.net] On Behalf Of harkema...@aol.com Sent: Monday, November 29, 2010 7:22 PM To: Chevelle-list@chevelles.net Subject: [Chevelle-list] fuel problem what could be the possible cause on a 350 chev engine after sitting over night the car will not start, it cranks and cranks and i can pump the heck out of it to no avail, i need to pour a small amount of fuel down the carb, than it will start and run just fine. if it sits a few hours it will start fine on its own. has to be like 8 or more hours. thanks Harlan
Re: [Chevelle-list] fuel problem
This was kind of on the line I was thinking, when the fuel pressure is measured- I quickly get 6 psi but it drops right off when I stop cranking. I also had the fuel line problem as discussed but replacing that did not do much good, neither did the carb overhaul. are there any tricks out there for replacing the fuel pump? don;t some blocks have a tapped hole in the front where you can put a bolt and bottom out against the push rod (holding it in place) thanks for all the advice!!! Harlan In a message dated 11/29/2010 8:42:57 PM Central Standard Time, a396...@fidnet.com writes: I just went through that with my 327 and Edelbrock carb. The fuel pump diaphragm had a small puncture that released the pressure between the pump and carb. Even the clear fuel filter I use was being drained dry. Dale