About $60 each. Get new, the don't live all that long.
Peter
___
http://www.okiebenz.com
For new parts see official list sponsor: http://www.buymbparts.com/
For used parts email [EMAIL PROTECTED]
To Unsubscribe or change delivery options go to:
Will leaking delivery valve seals on a 2.5t cause low power? I have one that
has 240D like performance at times it seems, has bad leaking seals, but runs
great. Will the leaks cause lower power or should I look elsewhere? Yes, I
will be replacing the seals anyway
---
Kaleb C. Striplin
Kaleb C. Striplin (CAT) wrote:
Will leaking delivery valve seals on a 2.5t cause low power? I have one that
has 240D like performance at times it seems, has bad leaking seals, but runs
great. Will the leaks cause lower power or should I look elsewhere? Yes, I
will be replacing
On Sat, 4 Aug 2007 10:33:27 -0500 Kaleb C. Striplin \(CAT\)
[EMAIL PROTECTED] wrote:
Will leaking delivery valve seals on a 2.5t cause low power? I have one
that has 240D like performance at times it seems, has bad leaking seals,
but runs great. Will the leaks cause lower power or should I
Trader
730 PP Supervisor
918-746-1400 x305
- Original Message -
From: Marshall Booth [EMAIL PROTECTED]
To: Mercedes Discussion List mercedes@okiebenz.com
Sent: Saturday, August 04, 2007 10:59 AM
Subject: Re: [MBZ] 2.5T, delivery valve seals leaking, low power?
Kaleb C. Striplin (CAT) wrote
No smoke with bad knocking at idle, smooth above 1500 rpm and low power
is the set of symptoms on my 300D that was cured by new delivery valve
seals. Bad head gasket didn't help any there, either.
No smoke, low power, and sluggish throttle reponse at low speeds can be
plugged fuel filters --
: Re: [MBZ] 2.5T, delivery valve seals leaking, low power?
No smoke with bad knocking at idle, smooth above 1500 rpm and low power
is the set of symptoms on my 300D that was cured by new delivery valve
seals. Bad head gasket didn't help any there, either.
No smoke, low power, and sluggish
When mine were leaking, they left a mess on top of the IP, left a
distinct Diesel odor as you walked by the car, and it required
significantly more cranking to start in the AM. I didn't notice any
change in power after replacing them on either the 603 or the 602
engine.
--
OK Don, KD5NRO
Norman,
Well, I check the alda line, it seems fine. On this car is a little
different than the 91. It comes out of the intake, goes to a Y, one of
the Y's go to the ALDA, the other Y goes to a pressure sensor by the
battery. Does not have the cutoff switch in between. I pulled the
codes and it had
Kaleb:
Pull a vaccum on the supply line. If it won't hold, the transducer is
toast. I'd replace both of them, it's been known to fix the problem
right up (or all three -- EGR, flap, and turbo boost control).
If any one of the three is bad, the computer goes to limp mode, self
explanatory.
Check the turbo and the waste gate control (electronic? If so, the
transducer is likely bad, no boost!)
Make sure you have good fuel delivery to the IP, too -- the hoses on
the suction side can crack and leak air in -- lotsa knock and lousy
power.
Peter
Kaleb C. Striplin wrote:
I also noticed while idling, if you run the engine ad various RPM,
the flap deal on the turbo outlet never moved at all. On any other
2.5 I have seen, it seems to move back and forth at various times if
you rev it up and/or down while sitting there.
I can't really
Wonder how much them things are. Maybe I should try some used ones first.
Peter Frederick wrote:
Kaleb:
Pull a vaccum on the supply line. If it won't hold, the transducer is
toast. I'd replace both of them, it's been known to fix the problem
right up (or all three -- EGR, flap, and
this motor is VERY quiet, cant hardly tell its a diesel(like all 2.5T's
should be)
Peter Frederick wrote:
Check the turbo and the waste gate control (electronic? If so, the
transducer is likely bad, no boost!)
Make sure you have good fuel delivery to the IP, too -- the hoses on
the
yep, mine does nothing. Im going to get into it tomorrow I suppose.
John Robbins wrote:
Kaleb C. Striplin wrote:
I also noticed while idling, if you run the engine ad various RPM,
the flap deal on the turbo outlet never moved at all. On any other
2.5 I have seen, it seems to move back and
15 matches
Mail list logo