On Fri, 4 Aug 2006, Steve Totaro wrote:
If your M13 is coming up clean, I'd double check the continuity to
those ports from the DSX connections out to the patch panel.
That was exactly the issue. The amphenol cable was loose on one end.
What is the best way to fasten these things?
I have a DS3/T3 that was dropped into my telco closet as two coaxial
cables. A send and receive. I needed to extend it so I went to Radio
Shack to buy some barrel connectors. They did not have any but they did
have T-Connectors so I bought a couple of those.
Everything was fine up until I
If you see no errors on your MX2800 for the ds3 then they are
probably not the issue.
What does the MX2800 show for T1 which do not work? If you loop
toward * does the card see itself? Loop toward GX do they see?
On Aug 4, 2006, at 11:15 AM, Steve Totaro wrote:
I have a DS3/T3 that was
I am not totally up to speed on the MX2800 but I have gone to loopback
tests and loop T1 25-28 and selected every possible selection while
watching pri debug span 1 on the console, no output at all.
Jerry Jones wrote:
If you see no errors on your MX2800 for the ds3 then they are probably
not
The MUX will give you stats for every line running through it, DS1,
DS2, and DS3. Start there. What errors is it reporting?
Actually I did that backwards, start with DS3 then do DS1, if 3 has
issues so will everything else.
On Aug 4, 2006, at 1:04 PM, Steve Totaro wrote:
I am not totally
On 8/4/06, Steve Totaro [EMAIL PROTECTED] wrote:
I am not totally up to speed on the MX2800 but I have gone to loopback
tests and loop T1 25-28 and selected every possible selection while
watching pri debug span 1 on the console, no output at all.
Jerry Jones wrote:
If you see no errors on
BJ Weschke wrote:
On 8/4/06, Steve Totaro [EMAIL PROTECTED] wrote:
I am not totally up to speed on the MX2800 but I have gone to loopback
tests and loop T1 25-28 and selected every possible selection while
watching pri debug span 1 on the console, no output at all.
Jerry Jones wrote:
If you
On 8/4/06, Steve Totaro [EMAIL PROTECTED] wrote:
BJ Weschke wrote:
On 8/4/06, Steve Totaro [EMAIL PROTECTED] wrote:
I am not totally up to speed on the MX2800 but I have gone to loopback
tests and loop T1 25-28 and selected every possible selection while
watching pri debug span 1 on the
BJ Weschke wrote:
It's a fairly common issue, and unfortunately, there isn't a best
practice solution that I've seen people use that isn't ugly. In a
prior job they zip tied the cables down to the connectors and this
fairly reliable.
At least on my MX2800s there is a loop for a zip tie on the
