NetWare 5 can use either IP or IPX or both.
You can order it from here:
http://www.novell.com/products/netware/evaluation.html
Bob
- Original Message -
From: Kirk Bollinger [EMAIL PROTECTED]
To: hal9000 [EMAIL PROTECTED]
Cc: [EMAIL PROTECTED]; Billha [EMAIL PROTECTED]
Sent: Sunday,
1. It'd have to be C
I believe network 10.1.0.0 would assume default mask.
As you said, B, D E are all wrong syntax
2. Not sure, but I'd go with C.
See here for more info on Atomic Aggregate:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/n
p1_c/1cbgp.htm
(watch
See Inline:
1) What is the size of a token ring frame?
My answer: Token ring has a variable frame size.
His answer: 3 bytes..
Isn't that the size of the Token frame?
There are 3 Token Frame Fields
- Start Delimiter
- Access-Control Byte
- End Delimiter
That's a pretty open-ended question. I don't think one could answer this
in an email. Your best bet is to go to Cisco.com and/or buy some books.
A few suggestions would be:
Cisco IOS Network Security - Cisco Press
CCNA/ACRC Study Guide(s) - Sybex
There's also a book by McGraw Hill that's
http://www.cisco.com/warp/public/474/
You should be able to find what you need there.
Bob
CCNP/CCDP (I'll only do that this once... just passed my CID - Yay!)
- Original Message -
From: Alex Soon to be CCIE [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Thursday, September 07, 2000
Title: password recovery file for PIX
http://www.cisco.com/warp/public/110/34.shtml
- Original Message -
From:
Syed Iftekhar
Ahmed
To: [EMAIL PROTECTED]
Sent: Friday, September 08, 2000 9:06
PM
Subject: password recovery file for
PIX
Hi all
can I get
You have to partition the Flash to make it one big (virtual) flash.
Check out :
http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/112cg_cr/1cb
ook/1csysim.htm#xtocid2402062
(watch the word wrap)
Bob
- Original Message -
From: "Ashfaq Aslam" [EMAIL PROTECTED]
Newsgroups:
Can we infer that you wish to run a Citrix published app, located in your
internal, from the Internet? I think we may need more information. I know
it can be done, though usually the Citrix server is sitting in a DMZ with a
public IP.
- Original Message -
From: "Steve Smith" [EMAIL
Yeah, I got one too. I doubt it's the newsfeed, as someone suggested, as I
haven't posted to the news.
Haven't tried it, though I'd be hard-pressed to knowing they spammed the
newsgroup.
Bob
- Original Message -
From: "McCallum, Robert" [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent:
We're upgrading our network soon. It'll look like the following:
http://www.erols.com/rtimmons/images/network.jpg
(I thought it better to do it in Visio than ASCII)
Each site will have 2-7206's that will each have 2 T1's mux'd via IMA cards
for 3Mb total to each HQ site. What we'd like to do
Greetings,
We're having a discussion at work on the merits of
moving the default gateway from our router toour switch. In a
nutshell, we have multiple IP subnets and 2 routers with secondary
addresses. I understand that the 'Cisco way' is to readdress so as to not
have multiple IP subnets,
Group,
A while back I read about a utility that would
compress an IOS image, but still allow you to use it. I found that I had
archived a copy on a CD, so I tried it out. It compressed a 14MB image
down to 4.5MB. I TFTP'd the compressed image to my 2524 and it
rebooted. Upon reboot,
The 4000, 6700, 7000 and 12000 series support T3 (DS3)
- Original Message -
From: D Stevens [EMAIL PROTECTED]
To: [EMAIL PROTECTED]
Sent: Thursday, July 27, 2000 10:32 PM
Subject: T3 circuit connectivity
All,
We are installing a T3 circuit (point-to-point between 2 local sites)and
That should do the trick. You would create
the access-list in priviledged mode [RouterA(config)#], not in the line mode
[RouterA(config-line)#]
Remember that this will allow ALL hosts within this
subnet and will disallow ALL hosts not in this subnet.
RouterA#config tEnter configuration
- Original Message -
From: "Bunchuck, Teyet" [EMAIL PROTECTED]
To: [EMAIL PROTECTED]; [EMAIL PROTECTED]; [EMAIL PROTECTED];
[EMAIL PROTECTED]; [EMAIL PROTECTED]; [EMAIL PROTECTED]
Sent: Wednesday, July 12, 2000 9:22 AM
Subject: FW:
-Original Message-
From: Vicente, Vicki
15 matches
Mail list logo