Load Balancing between two routers

I have three routers connected via token ring, A, B, & C. Routers B & C both have serial links to the same location. Can I configure router A to balance the traffic between routers R & C. Currently using static routes in A to send traffic to B only. Thanks! ___

RE: Load Balancing between two routers

Routing protocol in use on router A is OSPF. Routers B and C are not under my control, and while they too use OSPF, I would prefer to use static routes to the destination networks, as they have LARGE amounts of routing entries. The two serial links from B and C are both FR T1's. |+-

RE: Load Balancing between two routers

Well, then I guess my real question should have been on summarizing the routes coming into router A. Can you go into a little more detail on that? BTW, I don't have the 2nd router connected yet. I wanted to find out what would be involved firstso I can't tell you if the metrics are the sam

Re: Load Balancing between two routers

Currently, static routes are used between A and B/C (C doesn't exist yet) |+---> || sojourner9@ho| || tmail.com| || | || 07/14/00 | || 10:43 AM | |

FTP Throughput slowing down

Can anyone explain why, when I do an FTP from one location over a Frame Relay link to another, it starts out with a good throughput, but after a few minutes, drops significantly, and the total bandwidth is not being exceeded. There are a few routers in-between that I have no control over. Thank

RE: FTP Throughput slowing down

Actually, the one FTP server is within a "private" network. We have two companies that are connected via AT&T managed network. We're not doing any load control, nor is the other company, but I don't know what AT&T may be doing within the FR part... or their routers. |+--

Re: cannot map new DLCI

You get that type of an error if you previously created that DLCI and then deleted it, but did not re-boot the router. Once you re-boot the router it should work. |+---> || [EMAIL PROTECTED]| || et.sa| ||

RE: Redistribute OSPF to RIPv1 [7:69969]

you could try to configure area 1 range command at the abr, R2. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=70041&t=69969 -- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report miscon

RE: permit only even subnets [7:70039]

To match the even subnets, use access-list 1 permit 192.168.0.0 0.0.254.255 To match the odd subnets, use access-list 1 permit 192.168.1.0 0.0.254.255 Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=70040&t=70039 -- FAQ, list ar

RE: DLSW Icanreach [7:70154]

You should do bit-swapping because the routers will speak in non-canonical addressing. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=70164&t=70154 -- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.

bgp community [7:62326]

can someone help me? i am currently doing bgp in my test lab. i did a community no-advertise in one of the routes to be advertise by the local as to another as, but i can't see it in that other as. i also did a redistribution from bgp to igp (ospf) in the other as so that both bgp and igp would syn