configuring catalyst 1200 [7:52319]

Am not having any luck configuring a cat 1200 using hyperterm and the rollover cable and adapter that I used to configure a 2500 router. Am not seeing anything in the Hyperterm session. TIA!! Message Posted at: http://www.groupstudy.com/form/read.php?f=7i=52319t=52319

RE: configuring catalyst 1200 [7:52319]

Tim, I have a Catalyst 1600 and I had the same problem. Here is the work around I used: 1) I attached a modem to the console 2 I dialed in 3) I assigning an IP address 3) I disconnected and connected to the switch via telnet Try this with your 1200 ... Pierre-Alex Message Posted at:

Re: Configuring Catalyst 1200 ?

, or 1200. (Other comm settings are 8,none,1) Original Message Follows From: "Hans Schimek" [EMAIL PROTECTED] Reply-To: "Hans Schimek" [EMAIL PROTECTED] To: [EMAIL PROTECTED] Subject: Configuring Catalyst 1200 ? Date: Fri, 15 Sep 2000 22:10:40 +0200 i got a catal

Re: Configuring Catalyst 1200 ?

If this is an older Firmware switch, this cable must be a null modem pin... Good Luck !!! Phil - Original Message - From: "Hans Schimek" [EMAIL PROTECTED] To: [EMAIL PROTECTED] Sent: Friday, September 15, 2000 7:10 PM Subject: Configuring Catalyst 1200 ? i got a cat

Configuring Catalyst 1200 ?

i got a catalyst 1200 . it cannot be configured via the db-9 to RJ45 cable. the documentation says that i have to use the db25 to RJ45 cable. but i do not have a second COM Port with an RS232 interface. any advice ? thanx hans **NOTE: New CCNA/CCDA List has been formed. For more information