Hi Group
I want to configure frame relay switch. Here is
the thing I want to do:
I have three routers ( say R1, R2 and R3 )and two
serial cross over cable that has dte and dce
interfaces.
I want to configure router R3 as frame relay switch .
The DTE interfaces of cables I want to connect to
R
Try this out:
http://www.cisco.com/warp/public/125/fr_switching.html
""Arun Upadhyay"" wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> Hi Group
> I want to configure frame relay switch. Here is
> the thing I want to do:
> I have three routers ( say R1, R2 and R3 )and two
> se
er into a layer 2 device.
>
> http://www.cisco.com/warp/public/125/12.html
>
> Let us know if you get stuck...
>
> All the best !!!
> Phil
>
> - Original Message -
> From: "Arun Upadhyay"
> To:
> Sent: Monday, September 03, 2001 11:43 AM
>
t !!!
Phil
- Original Message -
From: "Arun Upadhyay"
To:
Sent: Monday, September 03, 2001 11:43 AM
Subject: Frame relay switch question [7:18318]
> Hi Group
> I want to configure frame relay switch. Here is
> the thing I want to do:
> I have three routers ( say
If the DCE interfaces are on the end routers you must use the frame-relay
switch and the frame-relay intf-type dce as well as the clockrate " "
command. Which ever router is connected to the DCE end of the cables must
have these commands entered on their serial interface. It really does not
mat
On Mon, Sep 03, 2001 at 02:27:26PM -0400, Lance wrote:
> If the DCE interfaces are on the end routers you must use the frame-relay
> switch and the frame-relay intf-type dce as well as the clockrate " "
> command. Which ever router is connected to the DCE end of the cables must
> have these comm
On R3,
Global config command of - frame-relay switching
then on each serial interface of the frame switch, you need to configure
some parameters. For example :
interface Serial0
no ip address
encapsulation frame-relay
clockrate 64000
frame-relay lmi-type ansi
frame-relay intf-type dce
7 matches
Mail list logo
