Usually this is from something at layer 2 or below. Verify that your
encapsulations are set the same and that you have good/correct cables. I
have had this problem in the past with bad cables connecting an external
DSU. Hope that helps
Tim
-Original Message-
From: [EMAIL PROTECTED] [mailt
"Line protocol is down" could have more to do with your IP schemes. change
or reenter ip addressing, verify same subnet. go to global conf. and type IP
routing. This may not be your fault so much as it is the routers code. Also,
down the interface, bring it back up and wait for 120 seconds. Do a s
Status Line Condition Possible Problem Solution
Serial x is up,
line protocol
is up
---
This is the proper status line condition. No action required.
Serial x is down,
line protocol is
down (DTE
mode)
Typically indicates that
the rout
it is a data link issue...forget about the masking.
without ip or with ip configed ..if you have the correct cable for bach
to back connection.
i would only check the clock rate statement on the DCE side and make sure
that the cable is good.
do s sho contr serial X
and check if in fact you have D
4 matches
Mail list logo