dlsw using frame relay only [7:24475]

Hi All, Has anyone managed to get dlsw working using frame relay encapsulation.(Direct Encapsulation) Are there any good examples anyone has that I could look at ? Cheers Richard Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=24475&t=24475 --

RE: dlsw using frame relay only [7:24475]

As long as you can communication using IP between the two peer routers (i.e. either both frame connections have an IP, are using unnumbered, or you setup the DLSW tunnel using a loopback), your DLSW tunnel should work just fine. Can you explain a bit more about your problem and perhaps post the c

RE: dlsw using frame relay only [7:24475]

Micheal, Thanks for the reply. I was looking at using the commands as follows for what Cisco call direct encapsulation , rather than specifying ip addresses as the remote peer destination GLobal config dlsw local-peer dlsw remote-peer 0 frame-relay interface s0/0 Interface commands frame-relay

RE: dlsw using frame relay only [7:24475]

Richard Botham wrote: I see what you mean about "direct encapsulation" now. I see how that would be fine if these are 2 ends on a point to point (many times when I setup DLSW in the past, the two routers at the end of the tunnel were spread apart across the WAN with many routers in between, so u

RE: dlsw using frame relay only [7:24475]

Mike, Thanks for that. I'll suppose this will only work as you say in a p2p setup. I will try the local dlci command as suggested. Appreciate you help here. Regards Richard Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=24768&t=24475 ---