:
Bcc:
Date: Sat, 30 May 2020 07:18:20 -0400
Subject: Re: Stus-List water pump seal
Yes. I just rebuilt my water pump on a yanmar 3qm30h. It was not that hard
actually. I ordered a major rebuild kit off Ebay. Once you clean the
housing the new bearings will seem very snug going in, which is normal.
T
Yes. I just rebuilt my water pump on a yanmar 3qm30h. It was not that hard
actually. I ordered a major rebuild kit off Ebay. Once you clean the
housing the new bearings will seem very snug going in, which is normal.
Take a large socket that fits the outside rim of the bearing and use a
hammer to ta
I had challenges in disassembly. Look at a drawing of the components first,
there are circlips on the shaft in an unusual location. The shaft won't
come out if they're in place.
On Wed, May 27, 2020, 15:36 Gerald Fennessey via CnC-List <
cnc-list@cnc-list.com> wrote:
> Any one have experience pre
Gerry,
When pressing in a new lip seal there are a couple of things to look for.
first make sure the seal is orientated correctly, the open side (side with
spring) should face the liquid
second I use a socket that covers the seal completely, I invert the socket
and then insert an extension and driv
Any one have experience pressing in a new seal in the 3gm raw water pump.
Thanks
Gerry Fianna 1985 35 MK3 ___
Thanks everyone for supporting this list with your contributions. Each and
every one is greatly appreciated. If you want to support the list
Seems like something I would attempt.
You might find a selection of sockets and an extension to be a valuable
alternative to a press for getting the seals in and out.
Josh Muckley
S/V Sea Hawk
1989 C&C 37+
Solomons, MD
On Aug 13, 2015 2:12 PM, "Charlie Nelson via CnC-List" <
cnc-list@cnc-list.com
>
>
> -- Original message--
>
> *From: *Charlie Nelson via CnC-List
>
> *Date: *Thu, Aug 13, 2015 11:12
>
> *To: *cnc-list@cnc-list.com;
>
> *Cc: *cenel...@aol.com;
>
> *Subject:*Stus-List Water pump seal replacement
>
>
> My Beta 28 HP dies
Raw water pumps are all basically the same. I think it can be done on your
level, take your time and use your phones camera to document each step. When
taking it apart lay the parts out in order of disassembly. Reassemble inreverse
order. The parts break down is usually a good indicati
My Beta 28 HP diesel, circa 2001, has developed a sea water leak on the engine
side/aft 'end' of the Jabasco (I think) pump which is driven directly by the
engine,
not by a belt. This engine has a primary coolant which is cooled by this water
pump circulating sea water thru a heat exchanger. BT