It shouldn't really be a surprise, but a number of folks have extra KSYN3
boards after they upgraded to KSYN3A. I am sorting through the email
offers, but looks like I will have no trouble finding one.
Dana
On Sat, May 1, 2021 at 12:39 PM Dana Roode K6NR
wrote:
> The cause of my chirp is
Good Evening,
It was a week of rapid growth. Ferns are now three feet tall and
leaves are filling the empty spaces in the trees. Bird species keep
changing. I heard a Mourning Dove the other morning. They are not
regulars here, must have been moving through. The gray jays are very
Sent from Mail for Windows 10
If you do not have the added 6 meter element it should be a worthwhile
addition. I think it makes the 3 element antenna
a 4 element antenna on 6 meters and greatly improves the F/B ratio and adds a
small gain. I have not added this
to my Yagi, since I seldom
The cause of my chirp is my K3SYN board; the intermittent nature was purely
related to what frequency I was on. Turns out when I was on 14044.74, plus
or minus a little, the chirp was there, even when I was transmitting at a
few watts out. I did the Config VCO Cal procedure Wayne mentioned,
Not upcoming, e season already in progress! Seeing at least single hop every
day.
Leave PR6 on all the time. K3 is deaf on 6 without it.
73
Josh W6XU
Sent from my mobile device
> On May 1, 2021, at 7:47 AM, Mike Flowers wrote:
>
> Hi Folks,
>
>
>
> I recently purchased a used PR6
Good work.
On 5/1/2021 9:45 AM, wa9fvp wrote:
I'm repairing a KPA500 for a friend that has the RX loss in standby mode.
After a time, he also lost receive in operate mode. After doing a teardown,
I found the problem.
With the PA board removed, I checked K23A relay. The normally closed
I'm repairing a KPA500 for a friend that has the RX loss in standby mode.
After a time, he also lost receive in operate mode. After doing a teardown,
I found the problem.
With the PA board removed, I checked K23A relay. The normally closed
contact on the antenna side of the relay was open.
Hi Folks,
I recently purchased a used PR6 6-Meter preamp in anticipation of the
upcoming 6M summer season.
My K3 has the KXV3A Interface option installed. I have a K-Line station;
K3,P3,KAT500,KPA500.
My 6M antenna is my SteppIR 3L.
I've downloaded the PR6 and KXV3A manuals, and
The switching speed should really be under 20mS to work reliably with an
Amtor modem. Pactor (as used by Winlink) is less critical. Computer based
transceivers can have slow change over due to long latency times.
My K3 and my Icom IC-7300 are fine on Amtor (and Pactor). I have a KX3 but
haven’t
9 matches
Mail list logo