Keith _always_ gives good advice. I would add one thing. Make sure the AUXIO
cable is disconnected from the back of the K3 when you do your testing. If it
is directly connected to a KPA500 or KPA1500, it just may keep the K3 from
shutting down. We don’t remember if the LCD will go blank in this
I'm not sure that boosting high frequencies (assuming you have simple,
age related, type losses) is really a safe thing to do. Whilst hearing
aids do this, they also apply dynamic range compression, to minimise the
additional hearing damage caused by the aid for loud sources.
Incidentally, th
Looking for a KAT500 preferably with Yaesu FTDX3000 cables. Thanks
Eric J Evans
ARS K4NDN
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:Elecraft@mail
I am listing this for a friend.
P3 Panadaptor, S/N 996 in excellent physical and operating
condition. Does _NOT have _ SVGA or TX monitor. Original manual
and required cables included. Power cable connects to D.C. output
of K3/K3s. I no longer have a need for this great accessory.
Hi Jim;
First, do NOT try loading FW, don't do a Parameter-Reset (EE-INIT) when
it is in this state.
1. Check the right side of the radio, it should be warm not hot.
If hot, then the 5 or 8 volt regulator is working too hard, either a
short or itself is bad.
2. More likely, C102 on the FP (F
You would need the most recent BLE 5.0 or above, with low latency support.
Then the delay is perhaps small enough that it won't make you crazy. I have
a Bluetooth transmitter in my bag to plug into devices that don't have
Bluetooth support, but I haven't used it for CW. Simple enough to use,
though
Turned on my K3s this morning and got a blank screen. Could not turn it
off after that without removing power. Haven't opened it up yet, just
wondering if anyone has encountered this and can suggest a good place to
start troubleshooting before bothering Elecraft's Tech Support with it.
Jim S
On 10/13/2021 9:18 PM, elelist...@elitemail.org wrote:
Headphones over these tends to cause feedback howl.
If your aids have programmable settings that you can select from a menu,
feedback could be eliminated by reducing gain when wearing phones.
For me, the direct connection to my receiver
8 matches
Mail list logo
