Re: [Elecraft] K3 + P3 + Microkeyer

2012-06-04 Thread Bob Lanning
Art - You have it right. In normal use the microHAM unit is in-between the PC and the K3 or if there is a P3 it is PC - P3 - K3. BUT when having to do FW update to the P3 or K3 or screen capture off the P3 the PC needs to be connected directly to the P3 or K3. 73, Bob - W6OPO _

[Elecraft] P3 SVGA interference -

2012-05-29 Thread Bob Lanning
In response to my message May 23, 2012; 3:27pm on the Elecraft P3 reflector Roger White W5RDW in Murphy, Texas responded off-list. He had the same problem I described. It was not coming from the K3 but from inside the P3. We both noted it started after installing the SVGA. During our

[Elecraft] P3 bandwidth

2012-05-01 Thread Bob Lanning
What bandwidth is the P3 using? 73, Bob - W6OPO __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by:

[Elecraft] Headphone vs Speaker volume

2011-02-12 Thread Bob Lanning
Does the K3 have a means to set the volume for speakers independently of the headphones? New headphones - specifically Heil's new ProSet with the HC6 element and the Elite have a lower audio output put. The K3 requires an AF Gain adjustment each time I switch between them. Some radios have a

Re: [Elecraft] Fwd: K3 Failed DSP Firmware Download

2011-02-06 Thread Bob Lanning
My first time FW upgrade failed too. The problem? I use Router a virtual port defining piece of software microHAM uses for their product's interfaces to such things as the microKEYER II. In their manual is a warning in Yellow to not perform FW upgrades via the microKEYER II interface which

Re: [Elecraft] Fwd: K3 Failed DSP Firmware Download

2011-02-06 Thread Bob Lanning
My first time FW upgrade failed too. The problem? I use Router a virtual port defining piece of software microHAM uses for their product's interfaces to such things as the microKEYER II. In their manual is a warning in Yellow to not perform FW upgrades via the microKEYER II interface which

[Elecraft] APF effectiveness...

2011-01-25 Thread Bob Lanning
APF ringing and over powering... I have had input from two Elecraft support fellows one of which was helpful. That being move the receiver off frequency (RIT) about 10Hz then adjust the APF center frequency to match. Some help - yes. But... The Elecraft implementation of APF in MCU 4.22 just

[Elecraft] APF ringing

2011-01-24 Thread Bob Lanning
Is there away for the user to adjust the APF? It is over powering and ringing. 73, Bob - W6OPO __ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: