From: elecraft-boun...@mailman.qth.net
[mailto:elecraft-boun...@mailman.qth.net] On Behalf Of Dick Dievendorff
Sent: Thursday, November 04, 2010 5:31 PM
To: k2qi@gmail.com
Cc: elecraft-boun...@mailman.qth.net; Elecraft Reflector
Subject: Re: [Elecraft] Firmware load
I'll add it to K3 Ut
gt; Sent via BlackBerry from T-Mobile
>
> -Original Message-
> From: Dick Dievendorff
> Sender: elecraft-boun...@mailman.qth.net
> Date: Thu, 4 Nov 2010 14:56:55
> To: Jim Bobo
> Cc: elecraft@mailman.qth.net
> Subject: Re: [Elecraft] Firmware load
>
> Remove po
2010 14:56:55
To: Jim Bobo
Cc: elecraft@mailman.qth.net
Subject: Re: [Elecraft] Firmware load
Remove power connector from K3.
If a P3 is inline, remove P3 power connector so that P3 will not power up, even
for a moment, when you reapply K3 power.
Reboot PC. This isn't often necessary
Remove power connector from K3.
If a P3 is inline, remove P3 power connector so that P3 will not power up, even
for a moment, when you reapply K3 power.
Reboot PC. This isn't often necessary, but sometimes a COM port or USB driver
is in an awkward state. If you don't reboot, do stop the K3 Uti
Turn off rig and close the K3 utility. Then try it again.
James K2QI
--Original Message--
From: Jim Bobo
Sender: elecraft-boun...@mailman.qth.net
To: Elecraft Reflector
Subject: [Elecraft] Firmware load
Sent: Nov 4, 2010 13:54
Power failure in middle of firmware load and now cannot
Power failure in middle of firmware load and now cannot connect with K3.
Anyone know how to get started again?
Jim, W5ODD
__
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.
I've sent a note to support, but anyone offhand know what E 000202 in the A
display combined with ERR DSE in the B display might imply about why firmware
won't load? I know that ERR DSE means a missing echo from a DSP command.
Right now K3 Utility appears to communicate fine with the radio, but
urned it back on I got two ERR
messages (sorry, I didn't write them down). I powered the K3 down then up a
second time, tried to reload only the DSP2 firmware and it took. All is well
now.
73,
Rich - K1HTV
= = =
Date: Fri, 28 May 2010 13:15:40 -0700
From: "Clint"
Subject: [Ele
I just had an issue installing the Beta firmware (3.97 - 2.58) on my K3. The
first 2 times I tried, the DSP load failed on both 1 & 2. As I just installed a
new RS232 card in my computer (my USB-232 converter scheme was quite noisy) I
assumed something was wrong with the new set-up. I went in an
9 matches
Mail list logo
